I have an ASA 5510 and CLI access.
I am trying to connect using ASDM Launcher or Java Applet.
I am able to connect to https://IP_Adress/admin and download launcher, it asks for IP/user/pass and then disappears and doesn't open anything.
With Java Applet it asks some questions user/pass/trust... then says please wait application will open in other window, but nothing opens, it just stays without doing anything.
I tried this on Mac and Win8 using different browsers and different JRE versions, result is the same.
ASA - asa708-k8.bin
ASDM - asdm-508.bin
Could you please help?
Can you share the java version in your PC's ?
If Java Version 7 Update 45 installed there was some problem in that . So kindly re-install with
version 7.1(5.100) or later
and same time check ASA Config
http server enable
http server idle-timeout 10
http server session-timeout 15
http 0.0.0.0 0.0.0.0 inside
http 0.0.0.0 0.0.0.0 outside.
. Please check & let me know the result .
I am using the latest Java 22.214.171.124.
all "http" commands, except the first one, returned:
ERROR: % Invalid input detected at '^' marker.
http server ?
configure mode commands/options:
A.B.C.D IP netmask to apply to the IP address, default is 255.255.255.255
enable Enable the http server required to run Device Manager
configure mode commands/options:
Hostname or A.B.C.D The IP address of the host and/or network
access the HTTP server
X:X:X:X::X/<0-128> IPv6 address/prefix authorized to access the HTTP
authentication-certificate Request a certificate from HTTPS client when an
HTTPS connection is established
redirect Redirect HTTP connections to the security gateway
to use HTTPS
server Enable the http server required to run Device
I have re-installed flash, i have installed ASDM in cisco ASA 5520 and enabled http server. still i am unable to access via ASDM.
Please anyone can help me!!
ciscoasa# sh version
Cisco Adaptive Security Appliance Software Version 8.4(3)
Device Manager Version 6.4(5)
Compiled on Fri 06-Jan-12 10:24 by builders
System image file is "disk0:/asa843-k8.bin"
Config file at boot was "startup-config"
ciscoasa up 48 mins 46 secs
Hardware: ASA5520, 2048 MB RAM, CPU Pentium 4 Celeron 1600 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash M50FW016 @ 0xfff00000, 2048KB
Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)
Boot microcode : CN1000-MC-BOOT-2.00
SSL/IKE microcode : CNLite-MC-SSLm-PLUS-2.03
IPSec microcode : CNlite-MC-IPSECm-MAIN-2.06
Number of accelerators: 1
0: Ext: GigabitEthernet0/0 : address is d48c.b55e.c446, irq 9
1: Ext: GigabitEthernet0/1 : address is d48c.b55e.c447, irq 9
2: Ext: GigabitEthernet0/2 : address is d48c.b55e.c448, irq 9
3: Ext: GigabitEthernet0/3 : address is d48c.b55e.c449, irq 9
4: Ext: Management0/0 : address is d48c.b55e.c44a, irq 11
5: Int: Not used : irq 11
6: Int: Not used : irq 5
The Running Activation Key is not valid, using default settings:
Licensed features for this platform:
Maximum Physical Interfaces : Unlimited perpetual
Maximum VLANs : 150 perpetual
Inside Hosts : Unlimited perpetual
Failover : Active/Active perpetual
VPN-DES : Enabled perpetual
VPN-3DES-AES : Disabled perpetual
Security Contexts : 2 perpetual
GTP/GPRS : Disabled perpetual
AnyConnect Premium Peers : 2 perpetual
AnyConnect Essentials : Disabled perpetual
Other VPN Peers : 750 perpetual
Total VPN Peers : 750 perpetual
Shared License : Disabled perpetual
AnyConnect for Mobile : Disabled perpetual
AnyConnect for Cisco VPN Phone : Disabled perpetual
Advanced Endpoint Assessment : Disabled perpetual
UC Phone Proxy Sessions : 2 perpetual
Total UC Proxy Sessions : 2 perpetual
Botnet Traffic Filter : Disabled perpetual
Intercompany Media Engine : Disabled perpetual
This platform has an ASA 5520 VPN Plus license.
Serial Number: JMX1513L0BV
Running Permanent Activation Key: 0x00000000 0x00000000 0x00000000 0x00000000 0x00000000
Configuration register is 0x1
Configuration last modified by enable_15 at 08:07:10.129 UTC Tue Nov 3 2015
To help rule out simple issues in configuration would you post the output of these commands from your ASA
show run | include asdm
show flash | include asd*
show run | inc http
This is a known issue.
Latest version of Java requires that you use the latest version of ASDM. Either upgrade ASDM or Downgrade Java.
It's just a Java 7 issue. Bug below:
asdm-7.21 will work without any issue. Otherwise, you will get hit by the bug mentioned above.