VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

This is the message I get after I type in all my passwordsThe secure gateway has rejected the connection attempt. A new connection attempt to the same or another secure gateway is needed, which requires re-authentication. Message received from a secu...

I have set up VPN on a stick on my router and my VPN is established but I cant get  to the internet after the client gets the VPN connection, my Nat translations are not taking place when i check using the show Nat commands.What I require is that use...

orahman99 by Level 1
  • 3501 Views
  • 25 replies
  • 0 Helpful votes

Hey Guys, ASA with 8.4I am trying to use the ASA as the DNS server for a small branch. The primary DNS server for the remote branch is across the IPSEC VPN. Everything works great on the inside. My problem exisits if I try to resolve the DNS from the...

Resolved! VPN IPsec with NAT

ASA5510, 8.0.xI need to set up a Site-to-Site (L2L) VPN with a remote location.The IT consultant of the remote asks me NOT to go out with my real (pulbic) IP address, but translating to a single IP address.On my side, I have a /24 network, at the rem...

battanc by Level 1
  • 687 Views
  • 2 replies
  • 0 Helpful votes

Are there any issues in running Cisco AnyConnect and Clientless SSL-VPN alongside each other??I am currently looking into adding AnyConnect functionality to an ASA that has currently configured to run Clientless SSL-VPN. The Clientless system will no...

Hello,I'm very confused about SSL with the ISA550.  Basically, I have SSL enabled on the ISA550.  I downloaded the AnyConnect software for my Android Samsung Galaxy S3 and I can connect to my LAN and the internet via the AnyConnect software from my p...

Hello,Shortly we are using a new ASUS Tablet withWindows 8 Version 6.2 (Build 9200) Cisco VPN Client Version 5.0.07.0410But trying to connect to our gateway delivers the following error:.Secure VPN Connection terminated locally by ClientReason 440: ...

tecciiiii by Level 1
  • 23614 Views
  • 8 replies
  • 0 Helpful votes

Hello AllI will be grateful if someone can assist me with this please.I am having issues with this setup and the VPN tunnel shows down. Can someone please advice where i may be going wrong. the test setup as below and i have also attached the current...

Was wondering if anyone has a working configuration for this setup up. Or point me in the right direction to get this to work. I basically want to get windows rt vpn to connect to the asa 5510. Thanks

Hi allIm hoping to get some advice on how to configure the following scenario.I have 1 HQ with External static IP and internal IP 192.168.1.0I have 6 Branch Offices all with External Static IP's and internal addresses that range from 192.168.2.0 to 1...

Hi,I'm setting up a simple LAN to LAN IKEv1 VPN between a couple of ASA 5510s.Using the sample config published in the 8.4 configuration guide I am able to establish a VPN tunnel between the sites, but ONLY if the the default gateway is set on each o...