I am using anyconnect client 2.3.2016. I am wanting to know if i can run a program(specifically a login script)automatically upon vpn startup. I am needing to run this client due to application reasons.
Good evening, First time poster, long time reader of these forums. I should probably stop to say thanks for all the advice I've managed to leech from the various comments that have been posted - thanks!My problem is getting to the stage of being a li...
I am doing a research looking for the best solution for a failover between two ASA and was hoping someone would like to point me in the right direction.The situation is as follows, we have got:- 2 Headquarters:Each is equiped with an ASA 5505- 10 Bra...
Hi Team,I would like to know about pre-shared key configured on router.While configuring site-to-eite VPN on two routers we are using pre-shared keys.Now we are configuring manually keys on both routers statically.Can we use any router as key managem...
Hello,I've looked all over the place for the MST files to customize the version 5.x and its manual but i could not find them. Has anyone done the customization on the client 5.x ? Regards
HiToday i'm running with an ASA 5510 at the HQ and a ASA 5505 at my home address with a site-2-site VPN connection.I'm only using the 5505 to hold this site-2-site VPN so it's a bit overkill.I would like a router at my home with build in access point...
I have two sets of local users who access internal networks vai the Anyconnect application on a Cisco ASA 5505.One user needs to access 1 ip address while about 7 users access abotu 4 addresses.I have a group called xyz1 which currently has the one u...
Hi everyone, I know know nothing about cisco devices. Just wanted to get that out there. I recently came to a job that has a 5505 setup as the network gateway, and as a vpn for employees to work from home via the Cisco VPN remote c...
Dear allI am setting up site to site VPN between two site A to B site. Two local site of A and B are connected fine. however for my site B have another internal MPLS to other site. The connection fine from LAN A all the way to LAN B MPLS router, b...
We are experincing a problem with only some of our home based users. they VPN in just fine and can reach any servers by using the FQDN such as internalhost.company.com, however they cannot resolve "internalhost". The issue seems to be somewhere betw...
We have 2 ASA's that connect to a 2811, but for some reason, the 2nd ASA wont connect anymore. Debuging ipsec or isakmp on the 2811 doesn't come up with any messages. External IP's still correct, and the sites can ping each other.Only debug on ASA f...
Hi Everyone,I have a similar problem, I'm able to connect via VPN client and ping only one host on the remote lan and nothing else. I'm using both split-tunnel and non-split-tunnel, but none has worked. My main objective is to make the remote u...
Hi Guys,We have Cisco AnyConnect installed on many computers and is working perfectly fine. Recently I installed Cisco AnyConnect client version 3.0.0629 on a new workstation and I get the follwing error message:'No valid certificates available for a...
