VPN

Hi   Site to site vpn on ASA firewall 8.4 version is not comming up. Any advise from your side.Phase one is comming up but not able to ping.Setup Is like belowCisco Router1 ==> ASA firewall ==internet ==Cisco Router2ASA configuration. crypto ipsec ik...

We have ASA 5510 and the Radius server.  We were able to login to Cisco VPN client last week.  For some reason, we got this error message in Cisco VPN client log:  "User does not provide any authentication data".  The authentication never went throug...

Hi Techies... Previously it was working flawlessly.I had to rework the router from scratch (don't ask).This time, VPN Client can connect but the local subnet cannot be reached.I can ping the router's LAN(int fa0 - 192.168.100.0/24) but not beyond tha...

According to Cisco datasheet, the Pix 515E has the following performances:• Cleartext throughput: Up to 190 Mbps• Concurrent connections: 130,000• 168-bit 3DES IPSec VPN throughput: Up to 135 Mbps with VAC+ or 63 Mbps with VAC• 128-bit AES IPSec VPN ...

HelloI have been trying for the last few days to set up a Remote access IPSec tunnel to my asa 5505 device. Phase 1 completes finePhase 2 completes fine The Cisco vpn client v 5.xxx shows that i am connected. But there is no traffic over the tunnel. ...

Good MorningI have an ASA 5505 with the Security License running 8.4 and 6.4.5 softwareI have a fully working VPN solution on there using a ISP IP - works fine.My boss wants to split the lines/bandwidth to another ISP we have coming into the office.S...

Hi, I'm a bit new at this and I wanted to know if this is possible with the RV042 or if there's a better product to use.  Our server is at located at location A and locations B and C telnet to the server via a VPN.  We're looking at getting another I...

How do I create a self signed certificate that does not use MD5 hash?  I have an ASA that needs to pass a scan, and this is the only thing showing up, port 443 for Anyconnect fails due to weak hash MD5.

Hi All,   This is our set up:Client -> Router -> Core Switch -> Subnet 1                                                    -> Subnet 2Is there a way to configure the Router (and Client) to allow the Client access to both subnet 1 and 2 behind the Ro...

This is the routing table of are VPN_ASAroute outside 0.0.0.0 0.0.0.0 20.90.21.1 1route inside flair 255.255.255.255 172.18.0.1 1route inside 20.110.208.0 255.255.240.0 172.18.0.1 1route inside 20.110.216.0 255.255.255.0 172.18.0.1 1 route outside 0....

HI , I have set a tunnel between Cisco pix 6.3 and Cisco Router 7200. Show Isakmp sa showing below detail on Pix Total     : 1Embryonic : 0        dst               src        state     pending     created    xx6.x71.x29.x68   x2.1x7.52.1x1    QM_IDL...

Hi,We have a cifs share to a user shared drive, where every user has a personal folder.  How do you lock this down so that each user can only see their own folder?  At the moment everyone can browse and open anyone else's files/folders.Thanks in adva...