VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

VPN is unable to connect with this error :"The client did not match the firewall policy configured on the central site VPN device.  Cisco Systems Integrated Client Firewall should be enabled or installed on your computer."VPN was working fine last we...

Hi,I have configured vpn remote access in Cisco PIX Firewall Version 6.3(3) the vpn work fine, I can conect since internet to my devices in internal network, but I dont have Resolution DNS,  the network inside  work fine. The dns server is in outside...

Acruzgreg by Level 1
  • 404 Views
  • 1 replies
  • 0 Helpful votes

Hello ExpertsOur office has a Cisco1812 and it provides outside user with remote-access via Cisco VPN client.I need to establish new site-to-site VPN with one of our branch. The  branch site is using ASA5505 (ASA5505 is configured already).In order t...

Hi,One of my customer is having problem on transferring dat over the GRE tunnel. He has GRE tunnel to the other site on 100 MB fibre from the service provider with EIGRP routing protocol. When he is downloading file from one site to other site, he ge...

This is the fifth router that has been set up to work with a remote firewall for VPN service. All five routers have the exact same crypto configurations except for the IP differences. The remote firewall has the same settings for each router except f...

jasonww04 by Level 1
  • 7656 Views
  • 4 replies
  • 0 Helpful votes

I have a linksys wvc2300 camera.  I had it up and running to where I could log in from a browser (on a local network) and view the camera.  However, I have since changed the port settings under the camera menu in the browser and now I can't remember ...

Hi,I'm setting up a remote access VPN on a PIX-501.When I attempt to connect through the software VPN, I'm able to connect however I'm unable to access any of the LAN resources.I've pasted below part of what I think is relevant of my configuration. I...

joanabotto by Level 1
  • 14710 Views
  • 10 replies
  • 0 Helpful votes

Hello Everyone,I'm trying to set up an Dual DMVPN Topology with HSRP configured between the two Hub Routers.HSRP  works fine. Concerning the VPN-Connection everything looks good too.  The Spoke Routers can connect to the Hub's LAN and the otherway ar...

rastaman2 by Level 1
  • 2164 Views
  • 5 replies
  • 0 Helpful votes

HiI am trying to configure EZVPN server on ASA and EZVPN client on 881 router. I found on the documentation to do NAT translation on the client sideMy confusion is that why I have to use the deny statement on the access-list? If anybody can explain t...

I am having trouble with remote access VPN on a PIX running 6.2, it's not getting pass phase 1 and the debug is saying that the attributes don't match. I am not sure if it is a VPN client issue or if it's a configuration issue, because the configurat...

Hello.I have a network where some spoke routers (branch offices , all routers are 2811) connect with IPSec VPNs over adsl lines to my central office and a 5540 ASA. Also there is a backup central site with another ASA 5540 where VPNs terminate in cas...