Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Resolved! VPN Config File

HiI have a quick question to ask, i have to transfer the config from one VPN concentrator to another one and i'm in the fle management section and i'm clicking  on the TFTP transfer but i don't know what commands to put in the fields.I see a box that...

scooter817 by Explorer
  • 2 replies
  • 0 Helpful votes

We have a ASA 5520 runningCisco Adaptive Security Appliance Software Version 8.2(2)We have a split tunnel using IPSEC to access our internal network. The access list for the tech group is pretty simple:access-list xxxx extended permit ip 255...

gginty by Beginner
  • 3 replies
  • 0 Helpful votes

I'm a little confused by this one.  What would case the default inspection policies to close RDP sessions due to inspection?6May 20 201015:40:05302014172.20.0.354938810.1.0.2003389Teardown TCP connection 708656 for VPN-DMZ: to VPN-Tr...

We have ASA 5510, running 8.2 (2) IOS.  We want to change the enable password.  Is this the correct syntax?enable password newpassword encryptedThanks.

laurabolda by Beginner
  • 8 replies
  • 0 Helpful votes

Hi, I seem to be having a problem with one of our newer routers and utilizing PPTP. The problem is that while the sessions connect fine, none of the traffic can route. It seems to work for about the first 3-5 seconds and then seems to drop all traffi...

How do I get split-tunneling to work in this scenario?  Core site, remote  I have the EasyVPN tunnel up and two-way.  I've followed Cisco documentation, but still the remote tunnels all.  What am I missiing?

Without any changes on ASA5520, our users couldn't use AnyConect last night.  (Cisco IPsec VPN client still works.)After entering the correct password, it showes "Establishing VPN _Checking for updates..." AND "Unable to establish VPN".Here is the lo...

schen by Beginner
  • 2 replies
  • 0 Helpful votes

I am in the process of setting up a new ASA 5520.  I am at the point where my remote client can connect to the VPN (authenticate) and receives an IP address.  But once connected the client has no access.  Cannot even ping anything other than its own ...

Hello,I have VPN between Cisco Asa 5510 and Stonegate (v5.1) and sometimes part of the vpn downs. I can do ping between some networks and with other networks in the same VPN I can't do ping.When I reload Cisco ASA all start workin correctly.These are...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers