VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

I am looking for a SSL VPN Solution for our Company that would scale to 700+ users in the next few years.  We are currently using the Avetail SSL VPN, and although it does a good job, the licenses are a bit expensive and we do have an opportunity to ...

Dean-VA by Level 1
  • 1047 Views
  • 3 replies
  • 0 Helpful votes

hi all , we have a scenario that a pix is installed in a remote site and has a vpn connection with the HQ (ASA 8) , the vpn is up but the I can't ping the LAN from eithwr both sites , but also I can do remote desktop from both sites ?!! can anyone he...

Resolved! Commands for ASA

What is the command to clear the screen? After typing the "show run" command, the screen will display many lines.  If I do not want to continue to see the rest of the config, how do I get out of the "show run" command.Thanks.Debra

Hello, I have an old pix515 witch I changed to ASA 8.04. I use DAP (Dynamic Access Policy) to match policies for the VPN users, I get the policies for the users from an LDAP (matching specific attributes that I have customized).Now I have a problem, ...

Hey guys, thought adding AnyConnect to my otherwise functioning configuration would be an easy job, unfortunately it isnt. I had remote VPN set up and can connect fine but needed to add the webvpn configuration to allow AnyConnect. The issue is whene...

Does any one know if PIX support PPPOA now? In the past that was not support but I am just wondering if Cisco added this in the current version.

dandis by Level 1
  • 348 Views
  • 2 replies
  • 0 Helpful votes

To all,I have a site to site vpn that works fine between Cisco 871 and 2801, however I need all traffic originating from the remote site destined to the internet to go through the host sites Internet access.  I've worked the the ACLs and have got it ...

I need to set up a vpn tunnel to a remote site.  Both our location and the remote location use the 10.x.y.z address scheme.  The remote end offered up a 172.16.6.0/27 net for a destination network.  How do I configure the ASA5510 on my side to create...

pootboy69 by Level 1
  • 504 Views
  • 3 replies
  • 0 Helpful votes

I have a VPN connection from an ASA 5510 to a 3rd Party Checkpoint FW.  Often the tunnel goes down and ISAKMP SA message is:1   IKE Peer: xxx.xxx.xxx.xxx    Type    : user            Role    : responder    Rekey   : no              State   : MM_WAIT_...

Hi AllI'm using a Cisco 881 router with IOS version (Cisco IOS Software, C880 Software (C880DATA-UNIVERSALK9-M), Version 12.4(24)T3, RELEASE SOFTWARE (fc2)).This router is used to connect a remote site (/24 network) to the company main site via a sit...

Has anyone setup anyconnect with AD Network. We want to setup a way to login to AD to get map drives and get in thru the anyconnect client. I read you had to do a xml profile. Not sure on this can anyone help with this. Thanks