VPN

Trying to work the last kinks out of 8.3 L2TP, I discovered that sometime between 7.2 seriesand 8.3, the ASA became unable to ride over an intermediate link with a low MTU.  Wherewe see this is on certain cable providers (read: Comcast) who set an MT...

What is the equivalent of this on an ASA?  thanks again

I have a client that has a 3rd party vendor needing access to a website that the client accesses over a site to site VPN.  Right now, the 3rd party vendor is using the Anyconnect client on some of their users computers.  However, some of the 3rd part...

We are attempting to setup a 5510 to use Radius pointing to a windows2008 server to authenticate remote VPN users. I have set this up with 2003 using IAS but 2008 replaces IAS with NPS. Attached is the meat and potatoes of the config and aaa server ...

Hi,we are trying to establish the VPN between Cisco 2811 router (Version 12.4(13r)T ) and PIX 515 E 7.01 and 7.23but we are able to get the VPN status UP but unable to ping the IP ( encrpt the IP on the router side )IPv4 Crypto ISAKMP SAdst          ...

Hi:I wish to know, how many VPN support the new ISRG2, due to the past routers with module AIM-VPN made VPNS.But now the new routers doesn`t have this module.Can you help me please.Regards.

I'm having an issue with the Mac version of the VPN AnyConnect Client.The Client I'm using is version 2.4.1012, and my MacOSX version is 10.6.4.The issue is that after connecting to the VPN server, everything will work fine for 5 minutes or so, then ...

Cannot get Mac Book to any internet sites anyconnect clients works fine with windows and not internet issues only with the mac is there any settings that need to be configured differently then windows since I'm not to familiar with mac. Any help.

Hello,First time poster here.I recently purchased a Lenovo T510 which has an Intel WIFI Link 1000 BGN card under Windows 7 (x64). Everything works fine with it until I try to use the VPN software over a wireless connection (everything is fine hardwir...

We own a /16 and will be extending a portion of it (/23) across a site-to-site tunnel.  What's the best way to define the crypto ACL?  The spoke site will be sending all traffic across the tunnel, but the core will only be sending the /23.  On the Co...

Hi,I have two offices, one in London on a 100mbit connection with pair of ASA 5510's and one in Malaysia on a 4mbit connection with a single 2811. The speed between the UK and Malaysian is quite poor so I am looking into doing some WAN optimizationI ...

Hello!I need to establish vpn connection over internet.On one side I have cisco 3845 which is directly connected to internet.On another side I have 2801, which is behind zyxel adsl modem in router mode (i.e. real ip is on modem, modem do nat for cisc...

I have SERIOUS issues with the latest ASA software version 8.3.  I have successfully implemented it on testbed ASAs and discovered what I consider to be inherent design flaws.  Upgrading our operational ASAs was so troublesome, I downgraded.- Migrati...

We have a group of VPN users that is connecting to the vpn using at least Cisco VPN 5.0.01.0600 or newer. Once connected to the VPN they do not have access to the internet and we would like to keep it this way for security reason. This group of vpn u...