VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

There is a Cisco 2861 router (IOS version 12.4(3f)) serving as a VPN concentrator. Average number of simultaneously connected users rarely exceeds 200. But sometimes the router stops accepting any new connection. According to output from command 'sho...

Last week, I assigned a test server Cisco ACS to act as the authentication and accounting device for a specific group on a Cisco VPN Concentrator 3060. When I looked at ACS, it appeared that not only the group was going there but others were passing...

dpatkins by Level 1
  • 651 Views
  • 4 replies
  • 0 Helpful votes

Hi, here is my situation, we have two ISPs in HQ, ASA has outside IP from ISP1, we have a WAN load-balancer sitting in front of ASA, when ISP1 goes away, the WAN load-balancer will NAT ISP1 IP to ISP2 IP.Now I want to implement site2site VPN redundan...

Hi, is it possibile to connect to an ASA appliance from a PC using the Cisco VPN client through a socks ? In other words, is it possible to socksify a Cisco VPN client ? If not, which is the best alternative solution ?Thanks in advance.

ASA5510 Security Plus 8.0(4) with 2 WebVPN licenses. I want to use the AnyConnect client at this time only.I configure an AnyConnect profile and add 10 local AAA usernamesOnly 2 can connect at a time. The AnyConnect client does get installed via th...

I'm trying to restrict the aliases user accounts can log in to when using SSL VPN. Right now I have several groups with different customizations, but every user is able to login to each of the aliases I've setup. The authentication portion is taken...

Hi after having an issue with my ASA 5520 Active/Standby i had disabled the failover on both devices. I then re-enabled the failover by issuing the failover command on the primary device first then the failover command on the second device.sh failove...

jtphilies by Level 1
  • 646 Views
  • 3 replies
  • 0 Helpful votes

Hello,I have a problem with my setup on asa 5505.Version of cisco is 8.0.2At the begin all the IP in the inside interface have a web access.I add a static rule for one IP of the inside interface , and after for this IP the web access does not run.My ...

I have a VPN tunnel with the following configuration:access-list DMZ_nat_static extended permit ip host [actual DMZ IP] host [Remote IP]access-list Outside_3_cryptomap extended permit ip host [one of my outside IP's] host [Remote IP]static (DMZ,Outsi...

smolz by Level 4
  • 372 Views
  • 1 replies
  • 0 Helpful votes

I have an 871W router with an IP phone. The phone is a NEC. The router is configured to establish a VPN to a PIX515e. From my understanding the tunnel is on demand. I have been having problems with inbound outbound calls. Is there a way to configure...

HMidkiff by Level 1
  • 582 Views
  • 3 replies
  • 0 Helpful votes