Showing results for 
Search instead for 
Did you mean: 

Forum Posts

Hello all, I am trying to set up IKEv2 tunnel with Windos Native client. I found some documentation for previous ASA, however I am not able to make it work on FTD. I need IKEv2 with certificate authentication.Is there any guide or recommendation for ...

If I am successful starting VPN before WIndows Login, which is a big IF since the VPN servers are overtaxed these days, Anyconnect doesn't provide positive affirmation that I was successful starting VPN.  It is difficult to tell the difference betwee...

JayBen by Beginner
  • 5 replies
  • 0 Helpful votes

Hello,My organization uses version 4.7 of Cisco AnyConnect. With a good portion of my workforce now working remotely I have seen more and more of my logged in users staying connected for days at a time. Pre Covid if I had a couple of users doing this...

Dear Team,I have using Cisco ASA I have configured L2TP/IPsec VPN, Users able to connect from out side network and able to reachable Inside Network but VPN users unable to use internet. When I will untick network gateway under VPN setting I will able...

sachinc01 by Beginner
  • 5 replies
  • 0 Helpful votes

Hi,Just looking to put this down and see if it flags anything. Windows 10 1909 build. Cisco Anyconnect 4.8.02045.Every 8 mins the VPN connection drops, reconnects fine.  Promon shows nothing unusual in windows at the time.  Wireshark shows the usual ...

Do0G by Beginner
  • 4 replies
  • 0 Helpful votes

Resolved! Anyconnect License

I need to setup ASA 5506-X for Anyconnect in the test lab environment for 2 users. Is there a license that is the chepest or wondering if there is any number of free license included. 

Sar891 by Explorer
  • 2 replies
  • 0 Helpful votes

Hello,I discovered the Cisco Packet tracer tool which seems to be a nice ressource.I'm trying to set a FlexVPN design with ISR4k. Even if I actiavted the securityk9 license, I don't see the ikév2 options :Router(config)#crypto ?dynamic-map Specify a ...

I have a vpn tunnel between a ASA 5506x and a Palo Alto PA220 firewall. The tunnel has been fine for the past 3 years it’s been up.  Starting since July the ASA started dropping packets.  Anywhere between 5 and 11% drop.  I contacted our ISP and had ...

Boleytech by Beginner
  • 1 replies
  • 0 Helpful votes

Hello All, I have configure an Asav on VMware esxi for lab purpose and need to setup and test anyconnect vpn for same. Currently my asav showing "Asav platform license state is unlicensedInstall Asav platform license for fully functionality" Is it ci...

vishal77 by Beginner
  • 5 replies
  • 0 Helpful votes

Hi Folks, I have a 5506x with the following configinside interface interface (Public NAT done at another device on the outside interface gateway) static routesinterface:inside gateway:

I tried asking TAC these questions, but they told me to ask a reseller.  My question is this.  Is the functionality for the AnyConnect Web Security module covered by the AnyConnect Plus license? Are any other subscriptions or services required to sen...

SMcCoy841 by Beginner
  • 3 replies
  • 0 Helpful votes
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers