VPN

Dear sir,i have two servers ip address:129.9.1.15,129.9.1.16 we want to access these servers through the asa5505 firewall.how can i configure the firewall plz any tips.thanks&Regardssrini

I am doing some testing with the cisco eagle server application but cannot access it for some reason... Here is the problem, my VPN client is connected through Interface 0/0 and the eagle server is connected through Interface 0/1 on a 2800 ISR router...

Hi, I'm trying to setup my pix515E ver. 8.0 to allow access to internet without using split tunnel. I am able to get connected, but unable to do anything else. Any help will be appreciated. I did try the vpn on a stick, but no luck. Also, tried s...

Hi,I try to make a tunnel to an ASA device with Anyconnect.When I start client from PC all is ok regarding contacting the secure gateway, authentication, but after that any time is made an update check and every time is starting the installation of A...

Hello - My VPN clients are having issues where they will lose connectivity to our Exchange server (they are using an Outlook client, not OWA). The stats still show the VPN tunnel connected and passing data, but they cannot connect to the Exchange se...

Hi, I can't get my site-to-site vpn to work. When I try to generate traffic from one internal host another. The trafic never arrives.Traffic flow:192.168.100.12 -> 192.168.100.1 -> 213.136.41.180 -> internet -> 79.136.112.50 -> 192.168.1.5If the ipad...

Hi everyone,I'm in the midst of configuring a VPN connection to a remote device and was wondering on the things i should take note of when configuring and then verifying conectivity.I have staged the necessary ACL for interesting traffic and all othe...

GentsI have site to site vpn it working well, Then VPN has been estaalished serveral years back , now clients are added (600No.s PC.) i want using additional subnet IP , but VPN should work without modify the client side firewall.i know client if add...

Does "pkts no sa (send)" mean that SA's are timing out too quickly? How can I mitigate this problem?Router#sh crypto ipsec sa detail interface: GigabitEthernet0/0 Crypto map tag: lajesvpn, local addr 208.4.63.99 protected vrf: (none) local i...

Hello,I've bought a 3g card from Cisco for testing and I'm having problems connecting the card to the 3g network. I've configured the card as I found on the cisco website. When I try to send data over the cell link the card makes the call to the BSS(...

Hi friends,Two VPN tunnels connect two remote sites to head office, both of them are working fine. But the two remote sites can not talk to each other, any ideas or solutions for this? Thanks.Here are the equipments and version:Head office: PIX515E 6...

Hi All,I have ASA 5505 with IOS 7.2 (3) -Security plus license acting as EZVPN server for few deployments.Iam planning to add another similar unit as standby (secondary)Current config (removed VPN related config)interface Vlan1 nameif inside security...

Does the SPA module on CAT6500 running sup720 with MSFC3 support DMVPN tunnels in hardware in crypto connect mode, I have gone thru a ton of cisco docs and cant get a definite answer. I will have dual hub dual DMVPN design co-existing with static GRE...

I am running VPN Client 5.0.03.0530. After the VPN client connects, launching any program on the local machine is very slow (approx 10 seconds). Once up, the program runs fine.Any help would be appreciated.