VPN

I have looked all over and can't seem to figure it out. How do you set an IOS device to use Main or Quick mode?Thanks in advance!

HelloI am about to configure a setup with a VPN network for a company. I will be using a ASA 5520 as the VPN concentrator and Cisco 800 series routers at the remote locations (about 200 remote locations).Now, if i don't want to configure a tunnel gro...

Hi all, I have inherited a network using DLSw and have limited experience. Previously all the traffic has been via TCP/2065 on Point to Point WAN or MPLS links through a PIX firewall. We have just started to test passing DLSw over IPSec VPN tunnels...

Is there a known way to configure an ASA5505 to use the built in Windows VPN client?

After installation I see a program-group called CISCO Systems VPN Client. After moving it into a sub-group like tools\CISCO Systems VPN Client the client does not work. Why? I have only changed the program-group and not the installation-folder!

Hi,I have a scenario with 2 NAS, everyone with 1 ISDN PRI. The 2 NAS have weighted static routes (redistributed via OSPF between the 2 NAS and the other routers) to foreign sites reachable via ISDN dial-out. What I want to avoid is the situation wher...

Can someone explain this error message to me and what I can do to fix it... "Secure VPN Connection terminated locally by the Client. Reason 403: Unable to contact the security gateway." I have un/re-installed the client and still recieving this messa...

When we connect with the VPN Client the Novell and Windows Networking is not operational. When we disconnect the VPN everything works fine.

my company is having 515E with fos 6.3and having 10 ipsec vpn tunnels with bandwidth 4 Mbps ... But I am getting only500 Kbps per tunnel ... what SHALL i DO to improve the bandwidth used by each tunnel.. when no other tunnel are active?I would be gre...

I want to setup ipsec vpn so that certain vendors can access their server behind the ASA5510, and only their server without using a radius server. What is the best way to accomplish this and what documentation can I use?

Can someone explain this error message to me and what I can do to fix it... "Secure VPN Connection terminated locally by the Client. Reason 403: Unable to contact the security gateway." I have un/re-installed the client and still recieving this messa...

PIX 515E's on both ends, one with version 7 of PIX IOS, and one with version 6 -- also, there are no firmware upgrades to the PIX running IOS v6.IPSEC VPN drops completely in a completely random fashion, and it comes back up after the SA's are clear...

My company is having PIX515E and having 10 VPN tunnel and 4 mbps bandwidth link to ISP ..My one tunnel through put couldnot exceed 100MB/sec per tunnel ..What shall I do to get 2 MB/sec VPN through put.Please, anobody can give clue to improve VPN tr...

Hi I have a Cisco 1721 with a WIC-ADSL in it. Trying to set this up but cant get it to work, tried this config: http://www.cisco.com/en/US/tech/tk175/tk15/technologies_configuration_example09186a008071a60e.shtmlI know my ISP uses the vci/vpi values ...