VPN

Hi, We've recently started getting weird behaviour on PCs with the Cisco VPNClient installed on them. We'regetting Event Id 5003 TrueVector Service failures and strange behavioursuch as tn3270 sessions timing out / dropping and also ftp clients fre...

I recently swapped an older vpn con 3030 for newer vpn con 3030. The new harder had updated OS 4.7.2.k. I had two sets of devices to change. On one of the devices I am now not able to access the device with HTTP or HTTPS. I can access with telnet...

Hi,I have a question about mode configuration. If the same peer makes several config requests to a router (an 871 in my case) protected by one IKE SA, will it always get the same IP address from the responding router?I would like to request more than...

I have cisco AS5300, he has 4 ports T1 and serial port.usually I configure it by HyperTerminal from my computer via serial port.i'm the administrator add and remove user accounts so people can pass with their names and passwords via dialUp connection...

Greetings,Currently I have around 50 users behind an ASA 5510. These users wants to connect to a remote PIX 501 using Cisco VPN client. But this is not working as no more than one Cisco VPN client is not supported on NAT/PAT.PPTP VPN is another optio...

Our webVPN users experience sessions drop out intermitently using VPN 3000. we gets the following error message in the event log:8853 03/26/2007 07:09:24.700 SEV=4 STC/4 RPT=326 60.49.118.57 CTX: 0x490006: Error(3/17): Detected error in SG protocol88...

Greetings,Currently I have around 50 users behind an ASA 5510. These users wants to connect to a remote PIX 501 using Cisco VPN client. But this is not working as no more than one Cisco VPN client is not supported on NAT/PAT.PPTP VPN is another optio...

I'm experiencing an issue similar to others posted in here. I have a 2611XM that is currently acting as a local DHCP server and firewall. I would like to be able to VPN to the router and be able to connect to the local network as well as the intern...

I need a little help with figuring out what hardware I need to use. In a recent post I was referencing trying to get this to work with pix 501 boxes, but I haven't had much success.I have three locations, Main office and 2 branch offices. Currently...

I have got same problem with VPN. Which was working 2 day ago..But now it is not.p.s.Last time when i sent an request to NetProf regarding this error, no answered were given...:( That time it was resolvedduty the misconfiguration at remote vpn end..B...

Hi, Everyone:I have setup a vpn with a customer, they have a single site and we have 2 sites.so vpn is setup as followingcustomer site to our site 1customer site to our site 2their source address will reach our one destiantion address.crypto access-l...

Hi Everyone:This is my secon post, desperatlely need to know whether or not what I'm attempting is even possible.I have a Pix into which both remote access and site-to-site tunnel sessions terminate (via RAN and Outside interfaces). Users are curren...

I'm running VPN Client 4.02 (B) on a Windows 2000 machine. Launching the client takes about 15 minutes before the client dialog appears on the screen. While trying to bring up the GUI, the CPU is completely consumed with the VPNGUI process. After the...