Showing results for 
Search instead for 
Did you mean: 

Forum Posts

SSL VPN Client and Verizon broadband card

Has anyone been able to get these two to work together? The Verizon PC card utilizes a PPP interface, and when trying to establish a tunnel I get the unable to modify the forwarding table. It works fine over an ethernet interface. I am using 1.1.0...

mcvosi by Beginner
  • 1 replies
  • 0 Helpful votes

SSL VPN Client

Hi everyone, I am doing some testing with the SSL VPN Client and i seem to be having an issue. The first connection will work ok, launches the SSL VPN Client installation and connects without any issues. The issue i have got is that once i discon...

murphyw by Beginner
  • 1 replies
  • 0 Helpful votes

Automate Branch Office Design

Hi,I work for a Managed Service Provider organisation and belong to the branch office solution group. I have very elementary knowledge about the branch office design aspect. I would like to know if we can automate the Standard design of a branch offi...

degug ipsec and isakmp

dear alli would like to be pointed to documents on the cisco web site, that interpret and explain all or the major output of debug commands related to ipsec and isakmp , thanks in advance

VPN tunnels between 3 sites.

I have 3 sites(A,B,C). A is connected to B thro' Site2Site VPN & also B is connected to C thro' Site2Site VPN. All 3 sites use PIX 7.1(1) for VPN connetctions. If I trace C clients from A client, it is only one hop thro' B. Everything working fine so...

tunnel issues

Hi;I have a VPN that is connected to a WAN Aggregator, i have multiple isp and one of the limitations is my upload speed. i get most of my sites to connect but there are a few that connect but don't pass data. the internal address on the aggregator...

vpn with access lists

in the peer model of VPN, whay using a shared router, we use ACL.do we use extanded ACL, and how it can be used to separate VPNs?can we permit access to Internet and deny it to other VPNs?

Trouble Completing IPsec Proposal - NAT Issue ???

I have a functioning DMVPN environment running with two hubs and approx 95 remote offices using 2621XM VPN Bundles. They have been functioning well for quite a few years now. I am now trying to bring up a new office with a couple of differences, th...

mbadali by Beginner
  • 1 replies
  • 0 Helpful votes

Dynamic Point-To-Point VPN

I want to implement IPSEC among 350 branches, all branches are connected to head office via point-to-point DXX circuits and radio's, i am unable to use DMVPN because it is use in multipoint netwroks. I made few changes in DMVPN configurations and con...

Two Tier Firewall Config

We want to setup a Data Center Network for core banking with all the application and Database servers.For the same we are planning to design a Two-Tier firewall network architecture. First Tier firewall (Cisco PIX in failover mode) will have Web serv...

fmatrine by Beginner
  • 1 replies
  • 0 Helpful votes

Wacky ASA VPN Access Problem

Hi Folks,I am currenty facing a situation and I am in real need for advice....The situation is that though ASA is allowing our remote branches to access the inside network and its allowing inside folks to visit Internet, its not allowing VPN access f...

nomanbari by Beginner
  • 2 replies
  • 0 Helpful votes
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers