VPN

I have a user that gets an application error when launcing the SSL VPN client:Faulting application Agent.exe, version 1.1.0.154, faulting module unkown, version 0.0.0.0, fault address 0x206c6544This is logged in the application event log under Applic...

I tried to configure SVC (tunnel-mode) on ASA 7.1(2) and I reach the stage where I can connect with the SSL VPN but I can?t access any resources in the network.Below is the configuration, appreciate any helpful assistance.. access-list WebVPN-ACL sta...

We're replacing a third party router with a Cisco 1721. This location is the hub of multi-location (3 remote sites) VPN.The 3 remote sites are all on fixed public IPs.I've seen examples of both no assupmtion/restriction of remote IPs (crypto isakmp k...

I'm testing my 3005 as a conduit to my Exchange Server 2003. Ext Interface is connected directly to the internet and Int Interface is on my LAN subnet. I have my E2k3 server configured in WebVPN - Servers and URLS as:Email (https://servername/domain/...

hi, i am using 2811 router at HQ which is connected with Leased Line, and 1721 Router at branch office connected to the internet through ADSL Line. Could you please help me to setup Site-to-Site VPN between these places. 2811 uses IOS ver 12.4 (6) T1...

Hi, after the start-up phase of an ssl vpn connection to a cvpn3005 4.7.2, after the first few packets on the channel, the ssl vpn client disconnects and connects again with the following message:"An SSL VPN reconnect resulted in different configurat...

Hi all, somebody know if is possible set a pppoe server in a cisco 877?I try with 12.3 YI3 (all modes) but doesn't work. However the same configuration runs in a 2600 without problems.Somebody can help me?thank you in advance

Hi, We have a Site-To-Site VPN between Cisco VPN 3000 Concentrator Version 4.7 and Cisco Pix 501 setup.I configured the 192.168.250.0 as the local proxy server and 192.168.73.0 as the remote proxy server in VPN concentrator. This VPN concentrator...

We have our VPN working, no problem. I can get FROM the workstation to the PIX Firewall, and into our internal network. However, I want to see if it is possible to either use VNC or Remote Desktop to connect back to the workstation, once the VPN se...

I am not a network guru, but a regular software developer. I have successfully used VPN client on my laptop, going wirelessly through a NETGEAR wireless router and connected to my employer's LAN.This week, I switched my ISP to VerizonFios. They gave ...

Hi all,I've 2 7204VXR with 10 ISDN PRI. I have different dialer belonging to different vrf: each dialer is associated to different PRI with rotary-group.Can I configure the multichassis MLPPP within this scenario?Obviously the 'sgbp member' will be d...

Hello, I have a user with a nortel vpn client installed, When trying to install the Cisco Client, The network cards become unrecognizable, and don't work. Has anyone found a workaround?

I am trying to set a VPN router to be the hub for numerous remote site VPN tunnels.At the moment, one peer is established and passing traffic with no problem.I have tried to configure an additional tunnel at the main site and debugs on the peer tell ...

We are looking at deploying an IPSec VPN from CE-CE routers across an MPLS backbone. There will be several CE, PE and P routers and we will manage the MPLS backbone. At all sites, the CE routers will be Cisco 7600 series with a VPN Accelerator module...