VPN

Dear net pros,Please kindly help me on the following1. PIX Firewall behind dsl speedtouch modem act as vpn end-point to terminate IPSec tunnel.What is vpn pass-through>What should i configure on speedtouch 510to pass the vpn traffic to the pix Please...

what should i do to telnet catalyst 4506 from pix?thank you for help?

Hi,I use a PIX 6.3 with an IPSEC VPN. I would like to log connection/disconnection of each user. The PIX logs automaticaly each connection but not disconnection. Do you know how to add these alarms ?Thanks a lot for each idea.

hello,I am new to this vpn concentrator 3000 so guide me how to start it...

Case Description: There is a PIX 501 firewall whose outside IP is assigned by DHCP server, while the inside is static 192.168.1.1. There are two computers behind this firewall (inside), with a private static IPs of 192.168.1.4 (Computer A) and 192....

I have a remote site that is using an telnet application and now they all are experiencing idle timeouts. Users are not losing connections because they still maintain connectivity with other servers in the headquarter office. Is it possible that the...

Can anyone give me some insight as to how I would debug a problem that everyday the tunnel between a pix and vpn3000 keeps dropping. The tunnel does not get used much, but later in the day when it is used the tunnel light is lit up but now traffic s...

I am a network engineer in a large medical practice. We have physicians that need access to two seperate network enviroments. Currently they have access to the universities resources using the Cisco IPsec Client. Is there a way to add security policy...

Sorry, I posted this yesterday in the wrong forum. Apologies to anyone who's read it twice...Hi Everyone,I'm trying to create a site to site VPN using our Cisco PIX515E (6.3) at our main office and an 837 ADSL router at a remote office.However, whene...

I have cisco 5350 with voip users, cisco using radius server to sevice voip users. Is it posible to use two radius server - if the first server fail then all accounting records will sand to another one ?

What commands would I need to enter to allow my users (a hand full) to connect via VPN to a 506E using the Cisco VPN client. I do not have a RADIUS server. Can I setup local authentication for this? If not, how would my users authenticate?Thanks.

we have the 831 router on one and and vpn3000 on the other and trying to create the tunnel between the two. Getting an error message "pre shared key already exists". I can't find the explanation anywhere on the Cisco site. Anybody can help please?

For a 192.168.1.0/24 my understanding is it equivalent to have a subnet mask of 255.255.255.0 --correct?Now what do the 20 and 22 stand for:172.16.0.0/202.244.32.0/22Thanks to help.Scott

If the system architecture is like this: Pix (501) and PCs attached to it. The PCs on the same subnet of 192.168.1.0 255.255.255.0. And a remote PC is to be assign a subnet of 10.10.10.0 255.255.255.0, once it is connected to the Pix via VPN.For a...

I have a 2610XM with async lines (octopus cable). each async line is connected to console port on another router. Through these async lines I can telnet to the 'another' routers from ethernet port on 2610XM. That's no problem. But I'd like to do th...