VPN

We are using a PIX501 with a default configuration, with a few VPN accounts setup as well.When users connect through VPN, using the Cisco VPN client with the AES-256 transform set (if that makes a difference), IMAP works (port 143), secure IMAP works...

Hi All, I have list of Mac addresses and also have range of IP addresses.. how to deny users with condition below: Range of IP addresses: 172.16.2.241 to 172.16.2.250 List of MAC Addresses: (stored in a file named maclist)01:02:03:04:05:0c01:02:03:04...

for killing a vpn client connection? I want to be able to kill a particular ip address that's using a vpn connection to my PIX.Any help would be greatly appreciated. Thanks in advance.LGIE

Hi all,I have setup a PPTP VPDN on a 1700 router. my internal IP is 192.168.0.0 and I use 10.1.1.0 range for my VPN local pool. is there a way to setup PPtp vpdn (like you do with PIX) where you can assign IP addresses from your internal IP range? I...

I am considering pushing out the SSL VPN client functionality but I am stumbling when it comes to the SSL Certificate installation. Can somebody give me a clue on how I am supposed get that Certificate installed? I apologize for my ignorance.

Client version 4.7.00.0510 on Mac OS X (10.4.2). Getting the following error message when trying to establish VPN connection "VPN subsystem unavailable". No problem when using the same Mac with the LAN interface. I know Macs r not the most popular su...

Hi all, I have a Cisco PIX-525 and am trying to connect it via the ciscovpn client software(3.0) using IPSec.It's always failed to connect.Istart the debug to get details when trying to connect.The following isthe debug information from the PIX con...

I have 2 2801s each with AIM-VPN/EPII-PLUS modules in them. According to the Cisco documentation, they should be able to support VPN at 100Mbps. We have a 3xT1 Internet connection at one site and DS3 on the other(hub). Both Internet connections are h...

I have a issue that i have not been able to understand and don't know where to look.I have a cisco 3005 running 4.7.2b and when a client connects everything works great BUT novell mappings. SLPINFO /a shows the slp being ok, and i can login ok. but...

My case is like this: an (web)applcation server hosts multiple web apps for the public to access. Moderate traffic. The server is located in a Commercial Hosting Company's server room. So the server can directly plug into the LAN (which is connected ...

Dear Allone of my vlan will need connect to vpn using private ip address to do the NAT.I can use ipsec and everything probably by using wired network.I can ONLY login the vpn client , and cannot run any application probably by using wireless network....

Hi,Does VPN 3000 Concentrator support destination NAT??Thanks in advance for your help.Regards,Shijo George.

I am connecting a remote site using a VPN between a PIX501 at the remote site to our VPN3030 on the local site. The remote site uses a cable Internet connection with a static IP. The connection works great but the IP subnet at the remote site dupli...

I have three networks on my PIX, outside, inside and a secury one in the middle.I have PIX OS 7.x installed and I can VPN fine to inside network and I can also use the PIX to access the internet from the VPN clients.My only problem is the "secure" ne...

Greetings, I have a ASA 5510 at work and I want to link my home network with my office network. I'm using Cisco VPN Client for Linux, but using this I don't know how to make my home network available from my office. At home I'm using 192.168.34.0/24 ...