VPN

Does the VPN Client need to be purchased separately if the PIX comes with VPN enabled?Thanks,Tom

Quick question for you PIX Gurus.I have a customer that has a setup similar to the one detailed here:http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080094cea.shtmlThis works fine as far as remote users being able...

Hello,maybe this is a newbie question, but i was unable to find an answer in all the PIX documentation about this - I'm still lacking to have a "big picture" how all the services on the pix work together:The PIX has one outside interface with a publi...

Dear Sirs,I have such problem:AS5300 at loading gives out the following message:"8PRI/4T board slot 0: Firmware sent a HALT interrupt".The Error Message Decoder Tool show:Error Message %MXT_FREEDM-1-HALT : 8PRI/4T board slot [dec]: Firmware sent a H...

I hav installed a cisco VPN client installed on a machine which logs on and is authenticated by a remote server without any problems.Now when i use the same ip address on a different machine.The VPN client commects to the remote hosts and an authenti...

Lately, we've had several VPN 3002 hardware clients start losing the user password when they lose power or get rebooted. We've tried upgrading them to the latest firmware (4.1.7.A) but are still having trouble with this.We've tried performing a syst...

Is it possible to forward UDP broadcasts (other than DHCP requests) through the PIX v7.0? Basically, I am looking to mimic IP helper address and the ip forward protocol udp <port> command in IOS. If not, would a tunnnel built through the PIX from ro...

Hello,I have recently upgraded from 6.3(4) to v7.01 and am having some problems with remote VPN connections.In the past we just used the PPTP and Windows XP connection to make a VPN connection.Now with v7.01 I see we have to use Cisco's VPN client, ...

please help to config or a link to do this tak. Thank you very much.

I am configuring an iPaq H3955 running Windows PPC 2003 to connect to my VPN 3030 (ver 4.1.7c) using L2TP over IPsec. I get the PPC to complete phase 1 and 2, but I then get disconnected with the following error message (from the Event Log in the co...

I just installed new memory in my old AS5300. Now I am getting the following error message. I know this is a stupid question, but could anything ELSE be causing this error instead of the memory? The only reason I ask is because I am able to RX-BOO...

I have problems with ipsec tunnels on pix 525 7.0. For some time everything is ok and then tunnels a messed up. when I go to monitor and then VPN and then look list of lan to lan tunnels, I can see that rx bytes is incrementing as remote location is ...

At home I have a Pix 501. At work we use a VPN 3000. Everyone else can connect and work from home except the users who have a Pix (such as myself). The VPN client connects (or atleasts says it does) however I cannot use any terminal service (ie Remot...

Hi, I would like some help please. I have created a vpn tunnel to another company location which works great. I now wish to set up remote VPN access from home workers to our head office using the same interface as the vpn tunnel is set up on. I h...