VPN

Hello, I am looking for suggestions as to how to ascertain which end of the tunnel (PIX to Netscreen Device) is not working. I see the tunnel but no traffic is initiated. Using "how crypto ipsec sa" I see the remote peer but note that there is really...

Hi all ,we have pix 515 configured like endpoint vpn , with 34 cilent vpn. Today ,all the client VPN disconnected to my pix after few minites when they are connected . thehave the same message " your VPN connection has been terminated " . The interne...

Dear Sir,I have a configuration like this,ACS --- Router with serial ----- Cloud service provider ---- branch routerFrom branch router there is DDR connection. So router dial over vpn dial tunnel, and then authentication username in ACS. branch route...

I have a uBR905 that I got off ebay and I am configuring it to work with my Comcast connection. I can get it to work in default bridge modem but I am looking for an example of setting it up for NAT.Does any one have a sample configuratioin I can loo...

Hi, Friends,I am now trying to setup a VPN channel from my PIX to a firewall of Stonegate, which is in another company and is not under my controll. But the VPN is not up, even phase 1 hadn't passed though. I constantly got the debug message in my PI...

Hi,Instead of creating a VPN viia Internett.Can i create that on Leased circuit....Please suggest...It's urgent..Thx

Are there any issues with using dialer persistent command on an dialer profile that also is configured to be the backup link for an frame-relay that is connfigured with backup interface command.Just seems conflicting to me since dialer persitent is s...

We have 3745 Router with E1 interface, configured for dial-in service with Toll free Number . What happens, user gets connected when dials through Tollfree Number and works fine. As per Telco ,the connection gets locked even after user disconnects t...

I am replacing an 827 router running DSL utilizing ATM PVC's...The 827 has no problem getting the SQL sessions through Term Serv....However, I have installed a 2811 in its place and running a NM-16ESW in it. ....I am doing voice and Data VLANS.....th...

It is possible?I configured my 2 sites with VPN site to site configuration..now i add the remote VPN for the VPN Software clients..now my site-to-site stop working..any ideas?

I have a ubr924 at home that i am trying to setup a vpn to my office (cisco 2600 router). i have setup the vpn's on both ends and notice that the office router is encrypting packets sent to my home and my home(ubr924) router is decrypting. However, ...

Hello,I have the following setup: Corporate Network---->FW------>PERIMETER ROUTER(no vpn support)----->internet(dial up)------>MSvpnclientI want to create the vpn tunnel between PIX FW & MSvpnclient(laptop user).I have configured the PIX for pptp but...

If anyone can pls assist me it would be much appreciated. Basically I have setup a remote access VPN from a PIX 515e running with a failover. IKE exchange works fine, but traffic is sent to the PIX fine, but statistics show no traffic is being return...

When using Cisco's VPN client 4.6 for windows, it appears to create a different IP address each time its used. Is there a way to force use of the same IP address each time its used?