VPN

Hi,I would like to know if it's possible that the vpn client send the user/password with which the user is logged in the pc but in a transparent way. After the user and password entered to dial, once stablished the connection, that the vpn client ini...

Hi,I have three Cisco 4500 and I want to setup them for DSL routing, so I'm looking for a Cisco IOS image, which supports PPPoE and vpdn.I couldn't find a image via the feature navigator,but I know, that the following image (or perhaps some other ver...

PLEASE HELP!! THIS IS DRIVING ME NUTS>>i have a PIX 501 FIREWALL...all is well, working on this unit i need a total of 3 VPN Tunnels, 1 site to site and 2 remote sitetunnels...problem 1:Once the tunnels are created and established, the VPN DCHP gives...

Hi I am using IPSec between 2 routers to secure a DSL connection between core and remtoe end. I have one MS 2K SP2 server at remote site and I have MS 2K server with Active Directory services running at core site. WAN DSL link provides sucessful conn...

Hello everybody,Sorry, I don't speak English very well, I hope you will understand !I 've got a PIX 515 as VPN server. I usually use VPN client with no problem but today I have to connect several VPN client behind one NAT public IP address and there ...

Hi,I want to configure TACACS on PIX 520 with ver 6.3.Can anybody tell me the steps & commands to configure Tacacs on PIXregards.Moorthy.

Trying to setup a Site-to-Site VPN between Checkpoint and Cisco Concentrator and I get an error message. Does anyone kwnow what this error is:Error processing payload: Payload ID: 1ThanksMehdi

Trying to setup a VPN on a PIX, tunneling traffic from a physical DMZ network to a VLAN trunked to the Inside NIC. Is this supported? The tunnels work correctly when terminated to the physical internal NIC, but it seems like the PIX doesn't termina...

Hopefully somebody else has seen something like this?For some reason connections from the cisco 837 site incoming to the enterprise bring up a tunnel and works the out put of debug at this time isIPSEC(validate_proposal_request): proposal part #1, (...

I have found several posts in this forum refering to PIX OS 7.00, it has been predicted that this version will fix the problem that remote access vpn clients terminating on a pix either have to use split-tunnel OR a corporate proxy to maintain intern...

VPN client 3.5.1 can not connect pix(6.3) by IPSec over TCP, How can I config the pix to allow IPsec over TCP?

I like to know is it possible to initiate a vpn connection from behind the pix firewall without doing nat or one to one mapping. I am using microsoft client to connect to the vpn server. it works if I map my ip to the Public ip but If I use pat It do...

Hi,I want to transport routing traffic across an IPsec tunnel between teo routers.I've used a GRE interface tunnel and applied crypto map over it... and all works fine.I'd like to understand why, I've to put the cypto map also over the physical outp...

I'm working on putting in two as5300's. One in Cal and on in Maryland. I'm using a telco 800 number to round robin between the two boxes. I have a single pri in each box and i'm using a ppp connection. Can I do this using one ciso vpn profile. I...

Hello,i have an access-router based on the cisco 3640 with channalized E1 and mica-modem.I would like to manage incomming Voice call on another DNIS and send it to a dial-peer. But i could not manage the called number for my modem because 3640 doesn'...