VPN

Hi,I am facing problem while initiating a remote access VPN connection from a VPN client ver 4.0.5 to a PIX firewall running PIX OS 6.3.The client throws an error saying no response from PIX.I did run a 'debug ipsec isakmp' on the pix and i am gettin...

Hi I have a configuration I'm working through. I have a 2651 router connected directly to the internet through a T1. There is a PIX 515 sitting behind the router. What we want to do is have VPN's terminate on the Router and then allow that traffic...

I am trying to implement a VPN over IP but can't seem to get it down. I went through all the literature in many places. I have a Netgear Router that accepts VPN connections. I tried to use the VPN software built into Windows but no luck. SO I bou...

Hi,I have configured the windows 2000 advanced server ca.Also, i have configured the pix with 2 isakmp policy.the first :Protection suite of priority 10 encryption algorithm: DES - Data Encryption Standard (56 bit keys). hash algorith...

hi, i have troubles with a lan2lan vpn connection between my cisco pix 520 and a linux freeswan 2.0.6 firewall. kernel version 2.6.8phase I is ok. i get the message QM_Idlebut phase II is not finished correctly. on both sides we have no spi connectio...

In this scenario customer has a PIX firewall and LAN inside. After firewall there is a cisco router with two WAN interfaces, one going to internet and other is IPLC to US LAN.We have set up VPN on PIX firewall for the internet users to access the IND...

Here is my config. I can authenticate over the VPN to my Windows 2003 IAS. The Cisco VPN Client says connected but I can't even ping the server at the remote site. When I check the statistics of the VPN Client, the route details shows Secured Routes ...

When a VPN device is said to support x number of IPsec tunnels, does this take into account all the SA's created when setting up the secure channel?So, does encryption for up to 3000 tunnels mean 3000 SA's or is it irrespective of how many SA's are c...

Hi all,I'm using a netscreen vpn client to TRY to connect to a pix vpn on a 6.3 pix501 (3des license). Here's the problem;I can connect to the vpn successfully, but I cannot get any traffic to flow. Once connected I try to ping the inside interface (...

Hello all. I have a VPN 3000 client in a remote LAN. He can connect and route traffic with windows Cisco client, but wit the Linux one, ha can validate but he ca´t send any traffic. I can see he is logged and the traffic is 0 bytes. My Split Tunnelin...

Hi, i have a domain name configure in a radius server... the attributes for the tunnel work fine on 5400 and 5800 RAS but when authenticating the domain on a 5300 the domain is accepted but it is not authorizated as you can see on the debug##########...

I have setup a GRE Tunnel across a service provider network using cisco routers. How can I protect this tunnel using IPsec? Does anyone have any documentation on how to achieve this?Thank you all.

Hi FolksI hv setup remote access VPN using PIX515 some time back & tested the same from the Firewall outside segment & also thru dialup and found to be working fine.After establishing Ipsec VPN,the user needs to access the server which is in the insi...

I have a main and remote site , main site has Windows Active Directory 2003 , DHCP , DNS, Exchange Servers and the two sites connected to the internet directly.The remote site has no servers , just internet connectivity , Does the VPN tunnel pass DHC...