VPN

I am using 3005 VPN Concentrators and all MS Win2K clients. They have various versions of the VPN Clientinstalled ( 3.63 - 4.05 ). All our client using IBM Client Access 4.3 and above for a 5250 client connection to an AS/400 Host.On about a dozen or...

I have my PIX 515, outside interface has a private IP address. It is NATted to a public IP address at the internet router.If I am using PIX VPN client at the other end to contact PIX, will htere be any issue due to NAT ?

We are planning on adding remote offices to our network, which would be connected back to our central PIX 515 via PIX 501 units at the remote location. I would prefer that the remote units get dhcp addresses on their outside interface, but can proba...

My question can we use ip any any in Ipsec point to point or hub spoke enviroment ? if not why?Regards

is there a way to terminate a vpn session from inside? please help, our network guy is out and my boss wants a connection terminated and we don't know how

Hallo,is it possible to creat one certificate for many user, and if so how can I do this.Is it possible to disable the questioning for the client-certificates if there is no password set?Thanks for reply

I would like to setup a client-to-site vpn on a 2651xm router over a dsl connection. does anyone would let me know what i would need to set it up. (ios version, client software, etc.)

Hello,Anyone else encounter any issue with IPSec clients installing SP2 on WinXP? I have some user complaints about not being able to VPN when they were able to do so before and the only change is the patch install.

Hi..I have a cisco VPN client [4.0.2(D)]. I need to know if it is possible to establish vpn connections to two different locations simultaneously using cisco vpnclient.I have two PIX firewalls running 6.3.3 in two remote locations (location A and loc...

From Pix 6.3(4) release notes :"If a VPN tunnel is initiated using a physical interface, logical interfaces cannot participate in the VPN tunnel."Could someone clarify this a bit please.Can I have use the "outside" as a normal (physical) interface th...

Hello everyone !I have a Cisco SOHO 91 connected to Internet with a DSL modem via PPPoE. This connection is working just fine, it is initiated on the router startup and reconnect automatically everytime the ISP cut it (every 24 hours).My problem is f...

I have a 515 with a site to site vpn configured on external interface and also a remote access vpn on the same interface. I know the pix cannot route traffic between these two vpns however I have heard it may be possible to "bounce" these off an inte...

Hello, can anyone shed some light on this, is this possible?TIA