VPN

Is there someone out there who has successfully installed CISCO's VPN client on a WinXP tablet pc ?We get error messages in the very first step of the installation. It makes no difference if we use the WinShield installation or the MSI Version. From ...

when accessing, from FW MC, the "Configuration ==> Setting ==> SNMP" option, I got the following error messages if my PIX config SNMP-SERVER LOCATION" parameter includes an ampersand character (& character) :You have encountered an ERROR!ERROR - The ...

I have read several posts about this not working when connecting to a VPN Concentrator. Not to mention I am experiencing first hand. Is anyone familar with why it work with MS-RRAS?I have searched and searched for related documentation but I can no...

Hi all,Is there any release of VPN Client (3015) for MAC OS 9?Regards,Carlos WelhousNetwork Engineer

Greetings:Is is possible to configure two VPN 3002 HW clients to communicate in a point-to-point configuration? I have tried a couple of configurations, but can't get and end-to-end connection established.My desired outcome is something like this:WA...

I have an existing ISDN connection with a different brand of router.Would like to setup VPN connection thru the purchase of PIX firewall to sit behind the ISDN router,is it a posibble solution

I'm setting up a PIX515e with v4.0.1 remote clients. The connection establishes, but apparently the PIX is not properly using the tunnel. The result is the client cannot access resources on the trusted LAN.Results of sh crypto sa: #pkts encaps: ...

Hi I have a mysterious problem with my DMVPN configuration. I have one hub (Cisco 1721 with IOS 12.2(13)T5) and two spokes (Cisco 1760 router also with IOS 12.2.(13)T5 ). Everything work’s fine until a moment when the tunnel interface (mGRE) of the ...

We are trying to upgrade from 3.6.3(REL) to 4.0.3(C).With our 1st version 3.6.3(REL), it was possible to install it from a networkshare. We had computer based policies that ran when an account needed the VPN software and this was done from a networks...

I'm trying to configure dhcp relay between two pix with a site-to-site vpn with out any success, I've tried with the following commands on the remote pix.dhcprelay server 172.30.xx.xx outsidedhcprelay setroute insidedhcprelay enable insidethe remote ...

Hello,I am trying to configure the pix for my client. The need vpn access to another company, but I am unable to connect. According to all the docs I found, I had to just add:fixup protocol pptp 1723nat (inside) 1 0.0.0.0 0.0.0.0 0 0global (outside) ...

Where I can find documentation on FWSM configuration and installation on CAT6500 running in Hybrid Mode.

hi alli'm looking for a way to configure ipsec passthrough on pix (performing pat and ipsec with a device on inside from a device on outside).this is possible on a ios plateform with these cmdes.int fast 0ip add ip nat insideint ser 0ip add ip nat ou...

I have a VPN site to site with 2 PIXes, to get access to an ftp server. My side is a 506E 6.3(3).If I permit ip as interesting traffic then the tunnel goes up and I can get access to the ftp server.If I define three rules to define ftp, ftp-data, and...