VPN

when I try and connect to my network using the Linux VPN client 4.0 I receive the follow error:./vpnclient connect <vpngroup> <user> username <pwd> passwordIncorrectly built binary which accesses errno, h_errno or _res directly. Needs to be fixedInit...

Here’s the deal. We have a satellite office that connects back to our corporate office via a fiber link that is supplied by our local ISP. This link is not live to the Internet but does traverse our ISP’s equipment at their NOC. In this case should I...

Hi I'm in a plan for VPN implementation.What is the minimum fixed IP addresses is required on 1 site.For etc I have a PIX and router connecting to the internet using ISDN.It just a simple network and there is no need for any static mapping such emai...

Hi!We are setting a hub (Point A) to spoke (Points B, C and D) VPNThe Hub is a Cisco 1760 with static public addressThe spokes are Cisco 827H routers with DYNAMIC public addressWe have no problem establishing the tunnels between the spokes and the ...

I'm setting up a test concentrator and was wondering if it was possible to use the VPN as its own CA. In otherwords, I want to use certificates without contacting a CA or setting up a CA server.

I have setup a site-to-site VPN between my company and a consultant firm, with PIX firewalls on either end. The tunnel has been created and communication has been established, however there is a problem with routing back to the consultant firm.There ...

Network Scenario :IPSEC network in star configurationCentral router with fixed ip addressPeers routers with dynamic ip addressAll the routers in the network have voice portsDue to i dont know the public ip address from peers, i need make the seesion ...

1. Multiple users, using cisco VPN client with no transparent tunneling enabled, connect to VPN peer through Cisco router (PAT). Can this be done?2. Multiple users, using cisco VPN client with NAT-Traversal enabled, connect to VPN peer through Cisco ...

Just wondering, i have two ISP for my office with an Amplifer(load balancing) in front of the whole network, and all the branch offices are connect through a LAN 2 LAN tunnel, with either PIX or router. Is it possible to program either PIX or Router ...

I need a configuration for a 1750 router to allow access from a Cisco VPN software client running on a W2k pc. The 1750 is connected directly to the internet on a serial port and into the network via ethernet. The 1750 is running NAT from the etherne...

vpn server is 515e ur,and use MS's radius server as AAA ,for instance,if one user named LEO dial in ,his ip address must be 10.0.0.100.can they realize it?if can't,can Cisco ACS realize it?if can,how to do it?if can't,how can I do it?

we are using Cisco VPN clients to connect into our PIX 515E using ACS3.1 and IPSec. How is it possible to assign fixed IP addresses for the users and control user login time?

Hi,The problem we have is that we can only have one user VPN'ed at a time. What the second user gets in the VPN client log is:1 18:29:59.766 05/01/03 Sev=Warning/2 IKE/0xE3000022No private IP address was assigned by the peer2 18:30:04.133 05/0...

When I visit a client that has a PIX Firewall setup and is passing GRE traffic and I try to PPTP into a different client somewhere else I'm not able to connect. I don't think the PIX is passing the right traffic. What command can I use to enable the ...

I have created an IPSEC tunnel with a preshared key between (2) 2600 routers with an hardware VPN. The VPN connection is seperated by 3600 router with a DS3 WAN connection to my ISP. I want to replace the 3600 router with a 7200. When I replaced the...