VPN

I'm trying to use a Cisco 837 with EZVPN to connect to a VPN 3000 Concentrator. I'm attempting to authenticate with XAUTH using SDI (SecureID tokens) on the VPN 3000 Concentrator. Establishing the connection is simple enough; I cannot, however auth...

Has anyone tried implementing this? I need to know if this only works with concentrator to concentrator only or will it work with a 3005 to 3002 as well? It is unclear in this document.http://www.cisco.com/warp/customer/471/config_vpn_3k_site.htmlI w...

Hello,we are currently running a VPN through the internet using IPSec tunnels (no GRE/IPSec yet). At our main office, we have a C3640 with one internet T1 and 30 tunnels to remote locations (static IPsec). Now, we are going to add a VPN 3000 series...

I'm able to connect to my VPN concentrator 3000, I can access all the resources in side and out side my network. I can ping resources inside my network, I'm not able to ping resources out side my network (e.q. www.yahoo.com) by IP address or name.

Hi,Is it possible to setup an IPSec Tunnel between a Cisco 1721 and PIX using IPSec\IKE (Dynamic Maps) with X-Auth ? While the X-Auth username\password are configured on the Cisco 1721 ?Regards \\ Naman

We have a few sites where we have deployed 1700 routers behind the ISP's CPE. We have set up VPNs back to corporate. Has anyone found a way to use GRE/EIGRP/something to cause the router to dial when the primary goes down and re-establish the VPN? I...

Hi there,Just wondering if it is possible to build a VPN tunnel from PIX to PIX withoutany data encryption. This will help increate performance on the boxes, althought I do not understand that it will not secure the data.Any help is greatly apprecia...

Even though configration are done properly on either side unable to establish the tunnel.

Is there a way to customize the text message which appears in the vpn client notifications window?thanks, wm

Has anyone heard of ABOT

Can one configure the group on a VPN concentrator to have access to a certain subnet? The client will be using Cisco VPN client 3.6.1. Our tunnel endpoint is a VPN concentrator 3060. I would like to restrict a particular set of users to one certai...

--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...