VPN

Hi, I have 2 remote offices facing the Internet each with 1 PIX (6.2) and I would like to connect the 2 networks with a VPN gateway-to-gateway.The problem is that one pix is behind a natting router (not controlled by my organization). A VPN client-to...

Has anyone configured a IPSec tunnel from a PIX 501 into a Shiva Lanrover Gateway (now called HP SA 3110 etc. as products are continued by HP)?All my attempts seem to fail.Thanks

I found several doc's on CCO about creating a VPN connection from a PIX 501 to a 3000 Concentrator using the VPNClient feature in 6.2.x of the PIX software (specifically "Configuring the VPN Hardware Client on PIX 501/506 Version 6.2 for Use With a V...

I have a working site<>site VPN w/ two PIX's. I need to restrict in-bound access into my private LAN to specific hosts a the protocol and port level. I can restrict to specific IP addresses but no granular. I need to apply the ACL to the outside int...

Dear all,Does it possible for PIX to create a VPN Hub&Spoke ?Regards,Engel

Hi,how can i list in PDM or Console the membership of connected VPN-User (Name) with internal and external IP ??Can i logg a Connection-History of VPN-User ??thanksRonny

I have set up my 515 PIX and I would like to make connection VPN clientwhen I connection with VPN client, it show following error message and It can't make connection successfully. Would u help to solve problem?1 13:00:29.910 04/30/02 Sev=Warn...

Having problems when I try to establish an Xwindows client session on a laptop equipped with the Cisco VPN Client v3.5.For all other traffic, we have no problems. The same laptop, when brought onto the private network can successfully start an X ses...

We found that the vpn 3000 client conflict with Window IPSec client. However, we got VPN applications that use both 3000 and a three party VPN device that use windows client. Does anyone know the possiblity of using VPN 3000 client with other VPN dev...

I am configuring my PIX 506 for VPN and plan to put it on my network which contains a single public static IP address, and I am trying to figure out the best way to do this. Do I use port forwarding on the router to send TCP port 10000 to the PIX,...

Can a Cisco VPN client be made to work through a shared connection using W2k Server RRAS NAT?I had something similar working when the shared connection was created using ICS on a W2K Pro machine and a dial-up modem connection. Now I've upgraded to IS...

Hi,I have a 2621 router currently being used to provide internet connectivity to 5 PCs. I am using a ethernet WIC for adsl with my ISP. My clients want to use the Nortel VPN client to connect via VPN. The router is currently configured to use NAT...

to all,i have a 2611 setup to be a vpn concentrator as well as other things. as it is now, i can vpn in fine, authenticate fine and get on the network. however once on the network, i can only ping one IP address, (unless clear ip nat trans *)or(wait ...

Trying to connect to our VPN concentrator and I get this error. I just started configuring our concentrator not sure if I did it right.1 10/19/2002 14:22:50.400 SEV=5 IKEDBG/64 RPT=55 64.173.199.201 IKE Peer included IKE fragmentation capability flag...

Have a 2600 with AIM-VPN. Never seen an AIM-VPN before. What is it? IS there any special IPSec configuration since I have it or do I go about my ISAKMP and Crpto-ipsec policy stuff as usual? Need a solid link or information on how to configure IP...