I configure VoIP through the IPSec tunnel between PIX 520 and the router 7201. The voice User Datagram Protocol (UDP) is marked as precedence 5 when leaving the voice router. Will the PIX keep the precedence for the voice UDP traffic after leaving th...
Hello, I am new to this forum, so bare with me. I am sure this discussion has come up many times before but I am going to ask again. I am including as much information as I can, in hopes that I will receive useful feedback.In the last few weeks I h...
I just bought PIX 501 and would like to test its vpn capabilites. I need to download Cisco VPN Client software, but seem to cannot locate it.... Do you have to purchase that separately than the PIX firewall ?? I first thought that it is included in a...
There appears to be a general problem with the use of VPN technology and Satelite services. In discussions with DirecWay technical support, they indicate the need to turn off IPSEC and select high ping rate. As use of IPSEC is fundamental to our ne...
HiI am really struggling to find a good document that fully explains what forms of VPN can and can't be achieved thru a NATT'D network. At present I am offering ISP services across my network that are NATT'D by a 7206VXR from our internet gateway, th...
Hi,here're the actual requirements:1.There're 2 sites leave apart:siteA and siteB.They connecte to ISP respectively.2.siteA needs access siteB's LAN rescources via VPN connection,not vice versa.3.The network diagram is like:siteA--->PIX515--->Router-...
Using Provider access for Internet connexion. Impossible to ping a remote workstation through a IPSec tunnel, VPN seems to be correctly established (show crypto isakmp sa --> tunnel created)If i replace the Internet network with a router, every thing...
Hi all I configured VPN access via PIX with token authentication (Cryptocard) .My customer want to create of reports of connection durations of VPN usersand also want to see which users connected.Token software doesnt have such as reporting capabili...
I am a novice so bear with me. When I authenticate thru the cisco vpn and do a status command, it says IPsec is not active. How do I enable IPsec. I am patched to a Linksys hub which is connected to a Cisco 806 router which is connected to a cable mo...
Hello All,I am working on a project plan that will enable a site to site VPN connection with our "sister" company. I believe that I understand the concept of interesting traffic between the peer sites, but I am still wondering how a user on the remot...
I heard of someone that you can not end or start an IPSec tunnel on a C7507.Is this correct and if it is possible do you need some additional hardware VIP?Is there anyone who has experienced this issue?
Hi,Can one create a GRE tunnel from an internal router, through a 3005/15 connected to either an ipsec router or hardware client, into another router at a remote site.Router <---GRE---3005/15 <----IPSEC--->H/W client or IPSEC router ---GRE--->RouterT...
Hello everyone,I was wondering if it is possible to configure a PIX 500 series running 6.1 to do transparent tunneling over TCP? The VPN client has an option to do TCP transparent tunneling, but I can't figure out how to setup the PIX to handle it (o...
-- begin ciscomoderator note -- The following post has been edited to remove potentially confidential information. Since this was posted on a public forum, it is recommended that passwords be changed including encrypted passwords. Please refrain from...
