VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

can i get sample configuration on implementing Lan to Lan vpn using 2621 routers with dedicated T1 line?

roloyede by Level 1
  • 1004 Views
  • 1 replies
  • 0 Helpful votes

I have a problem with a three sight VPN configuration. I use three routers (one Cisco 3640 and two Cisco 1720). I can´t connect to the Ms Exchange server behind the Cisco 3604 from the two Cisco 1720 sights. If i remove the static IP assignment apply...

kst_kla by Level 1
  • 966 Views
  • 1 replies
  • 0 Helpful votes

What would be the best design if you want to send multicast traffic over Internet using a LAN-to-LAN VPN with PIX Firewalls ?Use GRE Tunnels on a router before the PIX ? But what would you do with unicast traffic then ? Send that via the GRE tunnel a...

Remote user dial the internet and get a dynamic routeable IP and reaches one of my Secure tunnel gateway. The secure tunnel gateway in tern have meshed tunnel(IPSec) between three location. The Secure remote client would like to reach the servers in ...

selva_vel by Level 1
  • 1243 Views
  • 1 replies
  • 0 Helpful votes

Hi,My company is planning to venture into providing VPN services to the business community in the city. We are planning to build a data wireless network linking all the intended customers. The data wireless network will based on the Lucent Technologi...

We have to implement a customer site installation where two 2611s are interconnected via an IPSec tunnel and in parallel (outside the tunnel) run voice over VIC-2BRI-NT/TE cards (customer-owned Ericsson PABXs on both ends). The VICs are said to need ...

fabics by Level 1
  • 1030 Views
  • 1 replies
  • 0 Helpful votes

Hi,I am going to implement IPsec between 2 Cisco routers, I'll use IPsec ESP with tunnel, and I want to run ospf between the 2 routers over the IPsec tunnel.One of my colleague told me that this is possible, the IPsec tunnel doesn't support dynamic r...

vsbastien by Level 1
  • 5721 Views
  • 3 replies
  • 0 Helpful votes

Hi,I have a few site to site VPNs PIX-PIX. All of these work fine over frame relay connections. However, the first ISDN one I have tried fails?The ISDN router config is fine and I can ping the outside world from the PIX.Any ideas?

andrew by Level 1
  • 1205 Views
  • 3 replies
  • 0 Helpful votes

We have a 3-way PIX to PIX VPN, covering three branches around the world, when we connect with a PPTP client to one of the sites, we cannont see the other branches.Any ideas?

shai by Level 1
  • 1011 Views
  • 1 replies
  • 0 Helpful votes