Showing results for 
Search instead for 
Did you mean: 

Cisco CyberSecurity


Forum Posts

Hi community,Is there an API and code sample to connect to VPN from .Net app?The idea is to be able to connect to VPN from application and not to ask user to do so as credentials need to be stored from, this as a security request.Thanks in advance.

Hi,a customer use any connect VPN client with certificate authentication.The Certificates are User Certificates and everything works fine.The customer now want to use SBL and of course this doesn´t work with normal client certificates.So the client´s...

Hi I am configuring an IPSEC VPN on the ASA and I am a little unsure on the VPN ACL and would appreciate some advice. So this is a site to site VPN to a 3rd party and we will be accessing their systems. We both have clashing internal IPs so have deci...

I have a couple new laptops have Windows 7 64 bit installed. The latest vpnclient-win-msi- only support Windows 7 - 32bit.I am planning to try running VPN client in 32 bit compatibility mode. Has anyone using VPN client in Windows 7...

vinnieh by Level 1
  • 5 replies
  • 0 Helpful votes

Hi guys,I have a RV130W. I am trying to get my Mac to VPN to it. PPTP seemed to work using Shimo for a while until the upgrade to Catalina. Now I need a new option coz PPTP on Shimo for Catalina isn't supported. Is Cisco IPSec is different than regul...

Bluebeep by Level 1
  • 0 replies
  • 0 Helpful votes

Greetings, We just deployed AnyConnect 4.8.00175 to our MAC users in anticipation of macOS Catalina 10.15 (upgrading from AnyConnect 4.5.05030). Cisco AnyConnect 4.8.00175 is the first version that officially supports operation on macOS Catalina and ...

Screen Shot 2019-09-17 at 10.23.18 PM.png
w-vance by Level 1
  • 2 replies
  • 0 Helpful votes

Hello I have problem with flaping trunel between Router and tow ASA firewall    Here is my configuration with Router hostname Router!boot-start-markerboot-end-marker!vrf definition Mgmt-intf!address-family ipv4exit-address-family!address-family ipv6e...

Resolved! DMVPN per VRF Lite

Hi, I am running my DMVPN LAB in GNS3. R1 is DMVPN HUB, R3 and R4 are DMVPN Spoke with VRF isp1 enabled in WAN interface (Gi0/0).The syntax seems correct I can ping the tunnel IP address and enable OSPF in the DMVPN tunnel.But I still confuse with fe...

Yiwei by Level 1
  • 4 replies
  • 0 Helpful votes

Hello guys.I'm practicing IKEv1 tunnels and trying to set up an IPSec Tunnel to pass LAN traffic thru the tunnel between the 2 sites, and i also want the LAN network on each side to be able to reach "the internet", (i'm using nat overload for this).T...

RicardoSN by Level 1
  • 2 replies
  • 0 Helpful votes