VPN

I have a recently purchased an RV130 VPN Router connected to BT Infinity via a Draytek Vigor 130 modem, latest firmware, I am getting random pppoe disconnects. I turned debug on, everything works fine and then out of the blue the router sends 3 LCP e...

Hi everyone. DISCLAIMER: I am completely new to networking. I've got a decent shot at a job working on a VOIP project, so I am going for my CCNA Collaboration. Below is the config for my router in my home lab environment. My Router can ping external,...

Hello everyone I ask for help. Every 3 weeks drop the VPN and the status of it is as follows: IKEv1 SAs:     Active SA: 2     Rekey SA: 1 (A tunnel will report 1 Active and 1 Rekey SA during rekey)Total IKE SA: 3 1 IKE Peer: 192.168.119.1     Type: L...

Hi team...I need help to the below.   I set up a vpn client to my PC and went and configured a VPN to the router. I have the below logs all the time *Nov 24 09:10:52.385: ISAKMP:(1018):Sending an IKE IPv4 Packet.*Nov 24 09:10:52.385: ISAKMP:(1018):pu...

Need help on how to troubleshoot this issue and get a resolution. My team and I configured an L2L about 6 months ago and it has been working fine but all of a sudden the tunnel begins fluctuating (coming up and then going off). We have communicated w...

We have two offices (Office A and Office B) running L2L VPN setup between two ASAs. Office A has a DMZ hosting few servers. Hosts inside office A can access the servers but servers cannot access inside hosts in Office A (as expected from lower securi...

We are running Linux RHEL 7.4 with openconnect to connect to our ASA over SSL VPN. Since hostscan 4.3.05038 and onwards with fix CSCub32322: "cstub should validate server certificates for a ssl connection" we no longer are able to run cstub. If we ru...

HI,   I'm trying to have access with VPN client to an internal ASA using static NAT in a router 2951, the router has two ISPs directly connected and is connected inside to an ASA.   The router is using the two external IPs mapped to the same ASA inte...

Hi all,   I am getting an issue in configuring site to site vpn in cisco..   the error which I get while debugging are below:   phase 2 mismatch QM FSM error (P2 struct) Session is being torn down. Reason: Phase 2 Mismatch , Removing peer from correl...

Hi Has anyone had to open ports for a VoIP phone to work? Plugging the phone in directly to the Ethernet port of the modem is not working. Phone is displaying a 2011 signaling error. Called the ISP and they can't help with any configurations of their...

I'm looking for some insight or troubleshooting guides for our issue as our operations employee recently passed away, and I have no Cisco configuration experience.   We have a VPN setup with the Cisco ASA 5510 which uses a server on the inside to aut...

Good Day. How would one go about enabling anyconnect to 2-factor authentication using a one-time-pass/pin sent to the user's phone? I believe radius needs to be involved but I do not understand how and where the SMS gateway setup needs to be done.