VPN

Hi there,I have problem with cisco vpn client in windows10. I know that windows 10 does not support it anymore,and I have tried options written in glogs/forums.My problem is gateway does not answer (error 412) . I also tried in ubuntu box,the same pr...

Hello I have bought a certificate for my 2921 router and import the pki certificate,When i change the webvpn trustpoint to the certificate of the provider of identity the webvpn does nt work and i cannot connect.When i took the selfsigned certificate...

I am attempting to install the Cisco AnyConnect Secure Mobility Client on my Windows 7  64 bit laptop and gettng this message causing the install to fail.The problem began to occur after the hard drive was replaced on the laptop (Dell Laptop hard dri...

Hi, I have set up a VPN site to site using Cisco ASA 55xx Tunnel only comes up when traffic is iniciated only from the remote peer side. My packet tracer shows that VPN encryption is being dropped. When tunnel has been started by peer and is up, I th...

Hello! I'm having an issue with the Anyconnect and accessing other networks over Site2Site if the split tunnel is enabled. For instance, we have two networks one is 192.168.45.0 another is 10.225.0.0 the local network is the 45.0 and the remote netwo...

Router currently has (C184-ADVSECURITYK9-M) Version 12.4(15).  I know this is old, and the router is outdated and out of warranty but they are all using windows 7 PC's so I am hoping this will work.  They do not have an ASA.  Is there anyone that can...

I have a Cisco ASA 5510 with redudancy. 190.160.15.2 is Active unit and 190.160.15.4 is stand by unit.I want to reload both of them wuthout network down. what's the proper procedure for that ?Do i need to do forece failover then i ca reload the prima...

Hi All,Hoping someone might have an answer for me as this one has thrown me off. I have a VPN to Azure - 2 Networks on either side. Phase 1 and Phase 2 establish but only one tunnel is passing traffic. ASA Configcrypto map MYMAP 810 match address AZU...

Hi, We have Cisco anyconnect VPN and protocol we use is IPsec. I heard that IPsec is preferred to be used than SSL. 1. My management want to disable outside under 'webvpn' in order to not upgrade hardware.I don't really understand what this means.. 2...

I'm using Windows 10 and recently tried capture packets but there was no any capture interface came up after installing Wireshark. I noticed that I had to use Win10Pcap intead of WinpCap 4 something and I finally could see the capture interfaces. But...

Hi,I've a network that for its lan part is made of a single C class.Servers are in one place, a client (10.2.0.201) is in a different place, connected to the central site via two ubiquity nanobridge set in bridge mode.There are users that connects vi...

HI,I have 4 sites already connected to each other with mpls vpn.I need to add the fifth site but this, unlike the others, is not connected to the mpls network.The site "5" have a router RV320 , wan to ip public and lan 10.10.10.0/24With the instructi...