VPN

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco CyberSecurity

Labels

Forum Posts

Access to inside interface not working, it worked previously. Compared original configurations and not seeing any changes. what am I missing? Vlan 75 - Outside interface to an ISP DSL router Vlan 55 - Inside interface to 3750 with IP of 55.2. Unable ...

DON F by Level 1
  • 1590 Views
  • 13 replies
  • 0 Helpful votes

I need to apply dynamic and static crypto map to one interface. is it possible? crypto isakmp policy 10 hash md5 authentication pre-share!crypto isakmp policy 11 encr 3des hash md5 authentication pre-share group 5crypto isakmp key hronov address 50....

Hi All, I was trying to understand the output of the below command: How many SSL VPN sessions are permitted in this output? Is it 250 or 662? The license information shows 250. Please check the attached screenshot. ASA# show vpn-sessiondb detail Act...

Hello. I’ve been trying to figure this out for couple of days now and not getting much success. The situation is we have a need to two things: Client based VPN access for one person that is not able to use our corporate VPN solution, and a remote VPN...

Hello Experts, When I am trying to establish a tunnel between 2 ASAs, its not building up. I ran some crypto debugs and came across following error message. Jan 07 2016 05:18:20: %ASA-5-713050: Group = X.X.X.X, IP = X.X.X.X Connection terminated for ...

nshinde01 by Level 1
  • 9430 Views
  • 16 replies
  • 0 Helpful votes

Hi! I'm trying to make EasyVPN to work in my test lab, but it doesn't. I've ran EasyVPN wizard in CiscoCP, created local user and pool, selected pre-shared key, etc... but when I try to connect remotly using CISCO AnyConnect vpn client I always get t...

jmaurin12 by Level 1
  • 1756 Views
  • 3 replies
  • 0 Helpful votes

Hi one of our vpn was working fine today all of sudden it went down and we cant figure it out why this has happen. we trying to bring it up but it is not working I insert the photos and the output command please help. also remember nothing is change ...

Want to do some interoperate test. In the manual, it says: enable configure terminal crypto gkm group GET client d3p window {sec seconds | msec milliseconds} exit show crypto gkm gm replay but there is no "client d3p ..." command,  what i'm missing ?...

plane-sky by Level 1
  • 191 Views
  • 0 replies
  • 0 Helpful votes

I've a Cisco 819 4G router. I want to access my synology NAS which is connected on the local network,  from anywhere in the world using the internet. Is this possible?? and can someone tell me how i can configure the router so i can reach this NAS u...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: