VPN

Hi All, I'm going crazy with a Cisco ASA running 8.2 which won't allow traffic to pass fron the Anyconnect VPN into the internal network. I can connect fine and get the correct DNS but then cant communicate with the internal network. I beleive I have...

Hello,We have a IPSEC vpn between our office and a vendor. I can reach their resources but they are unable to ping mine 192.168.26.10. I see lots of decaps but no encaps. Can anyone assist? Thanks in advance. Scrubbed config below and outputs. !hostn...

Hello, looking for some direction on a network deployment. We have approx 15 sites, two being hub sites and the rest remote sites. All sites have primary and backup internet connections, as well as a private Ethernet over fiber link. Hardware will be...

Hello everybody,I set up a Cisco RV180 VPN Router with VPN (PPTP) enabled. Everything works fine so far. When i'm connected to the VPN from a remote Network with an iPhone, iPad or Notebook i'm able to ping all devices and to reach the setup pages wi...

Hi, we are facing some strange problems with a VPN connection. We have three networks:The destination network (172.16.0.0 /24), the network of our  headquarter (192.168.50.0/24) and the network of our branche (192.168.60.0/24).In the headquarter we a...

Hi All,I am having issue with one of the IPSec tunnel, I have tried every thing I could but the phase of IPSec is not encrypting or encapsulating, however doing the decryption and decap with no issue, so traffic pretty much looks like unidirectional ...

Some of our users (e.g. researchers, technicians,...) need to connect to multiple VPN Gateways outside the scope of our Installation, often alltogether  different companies. They find it tedious to manually change the gateway in the connection tab ba...

Does Cisco Anyconnect Premium (clientless) VPN support Windows Remote Desktop 2012 Remoteapps? Looks like there is only specific types of programs that work with the clientless vpn, though I am having a hard time finding documentation on this Any adv...

I have a ASA5512X base license. Running though the Wizard to setup AnyConnect. When it applies the config I get. . [ERROR] crypto ikev2 enable VPN client-services port 443IkeReceiverInit, unable to bind to port I've tried about a dozen ways to get th...

Hello, Need your help on the L2L VPN issue that we are facing. Our Phase 2 lifetime is set 3600, every 50 mins when the rekey happens, the VPN tunnel terminates & will be up again after 10 mins. So it happens every hour. The other end of the tunnel i...

Hello all,I'm currently investigating whether it's possible to allow PPTP tunnels while a user is connected to Cisco AnyConnect SSL-VPN, because this functionality does not seem to be working. the situation is the following: - The customer has a Cisc...

hi i have to create a site to site vpn for an ASA to a C3945 (15.2) router. I'm used to site to site vpns, just not the VRF part.I'm configuring a sub-interface on the 3945 that is part of a vrf.I'm just checking my config is going in the correct dir...

I have been using a Windows Phone for 6 months and would very much like to use VPN.  Our IT team indicates that without the Cisco Anyconnect app, I cannot accomplish this.  Is Cisco planning on developing an app for Windows Phone?