cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
5948
Views
0
Helpful
9
Replies
SilentHunter124
Beginner

Can not connect to easy VPN Server

Hi *,

I have a little stupid problem with my easy VPN Server. I took the following configuration to configure the VPN: Click

I can successfully ping 192.168.99.1 but when I start AnyConnect (enter this IP-Address as serveraddress) on my IPhone, it first says that the server certificate is not valid (I ignore that because it is self signed..) and when I press continue it says that no connection could be established.

What can be the problem?

1 ACCEPTED SOLUTION

Accepted Solutions

It's very likely that you don't have a PAT-pool configured and just use the "overload" keyword when NATing to your outside interface. In that command you reference an ACL (or an ACL in a route-map) where you have to make sure that your VPN-pool in included in the NATed traffic.

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni

View solution in original post

9 REPLIES 9
Karsten Iwen
VIP Mentor