02-08-2003 05:26 AM - edited 02-21-2020 12:20 PM
I've just recieved a 515 and 525, but I've having difficulty in verifying the accelerator cards as listed are present. What is the command I'd use, and what am I looking for in the result?
Thanks.
02-09-2003 04:25 PM
A "sho ver" should show:
pix525a# sho ver
Cisco PIX Firewall Version 6.1(2)
Cisco PIX Device Manager Version 2.0(2)
Compiled on Mon 31-Dec-01 08:44 by morlee
pix525a up 8 days 6 hours
Hardware: PIX-525, 256 MB RAM, CPU Pentium III 600 MHz
Flash E28F128J3 @ 0x300, 16MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB
Encryption hardware device : IRE2141 with 2048KB, HW:1.0, CGXROM:1.9, FW:6.5
0: ethernet0: address is 0002.b945.a23b, irq 10
1: ethernet1: address is 0002.b945.a23c, irq 11
2: ethernet2: address is 00e0.b602.3a1f, irq 11
3: ethernet3: address is 00e0.b602.3a1e, irq 10
4: ethernet4: address is 00e0.b602.3a1d, irq 9
5: ethernet5: address is 00e0.b602.3a1c, irq 5
6: gb-ethernet0: address is 00d0.b7b9.d756, irq 5
Licensed Features:
Failover: Enabled
VPN-DES: Enabled
VPN-3DES: Enabled
Maximum Interfaces: 8
Cut-through Proxy: Enabled
Guards: Enabled
Websense: Enabled
Inside Hosts: Unlimited
Throughput: Unlimited
ISAKMP peers: Unlimited
Note the "encryption hardware device" next to the ethernet ports list. Failing that, open it up and look for this card (http://www.cisco.com/warp/public/cc/pd/fw/sqfw500/prodlit/vac_ds.htm)
02-10-2003 03:41 AM
Nice one, thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide