Cisco AnyConnect Secure Mobility Client - Shared Key Auth

[nikitazernov]

Hello everyone! I am trying to open VPN tunnel to my Cisco 1800 series using Cisco AnyConnect Secure Mobility Client. On router I setup EasyVPN server with shared key auth. Client even does not ask for shared key, group, etc. I just can see:

21.01.2016
10:39:08 Contacting  /...................../
10:39:14 Connection attempt has failed.
10:39:14 No valid certificates available for authentication.
10:39:14 Connection attempt has failed.

How to properly use Cisco AnyConnect Mobility Client with shared key auth?

[jagmeesi]

Hi,

Please try to verify the config use the following DOC as an Example(i suppose you are using SSL):

http://www.cisco.com/c/en/us/support/docs/routers/3800-series-integrated-services-routers/110608-ssl-ios-00.html

If possible please share your configuration.

Note : AnyConnect Uses SSL and IKEv2 as Client VPN protocol, these doesn't have pre-shared authentication.

https://supportforums.cisco.com/discussion/12237241/anyconnect-ikev2-psk-pre-shared-key-possible-under-ikev1-cisco-vpn-client

Regards

Jagmeet