cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1035
Views
0
Helpful
8
Replies

Cisco ASA 8.2 - anyconnect-essentials

Ranbeckycr_2
Beginner
Beginner

Experts

I need to enable the command anyconnect-essentials in my webvpn configuration.

When I do show run webvpn  I see:

no anyconnect-essentials.

If I go to webvpn:

(config-webvpn)anyconnect-essentials  ( then hit enter)  I get this error message:

Clientless sessions currently active:3

After all clientless sessions are disconnected, manually enable Anyconnect Essentials using ASDM or "anyconnect-essentials" CLI under webvpn mode.

For some Reason JAVA is screwed up and I can't run ASDM. 

How Do I disconnect the Clientless sessions via CLI in order to add the command

"anyconnect-essentials"

Thanks for your help!!

1 Accepted Solution

Accepted Solutions

Marcin Latosiewicz
Cisco Employee
Cisco Employee
vpn-sessiondb logoff ....

View solution in original post

8 Replies 8

Marcin Latosiewicz
Cisco Employee
Cisco Employee
vpn-sessiondb logoff ....

Marcin,

Thanks for the quick response.

Question, will this only disconnect the Clientless sessions or will it also affect the other SA's?

If I run a show cry isa sa ---> It shows    Active SA:  57

I need to know if these 57 VPN tunnels will be affected.   :-)

Thanks again!!

vpn-sessiondb logoff

To log off all or selected VPN sessions, use the vpn-sessiondb logoff command in global configuration mode.

vpn-sessiondb logoff {remote | l2l | webvpn | email-proxy | protocol protocol-name | name username | ipaddressIPaddr | tunnel-group groupname | index indexnumber | all}


Cisco Network Security Channel - https://www.youtube.com/c/CiscoNetSec/

I am somewhat puzzled. When you look for show cry isa sa  you are looking for ISAKMP but this is used for IPSec. I would expect the clientless and the AnyConnect sessions to be SSL based and not IPSec ISAKMP based.

I would also ask whether you already have installed the AnyConnect Essentials license on this ASA.

HTH

Rick

HTH

Rick