cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
58
Views
0
Helpful
0
Replies
Highlighted
Beginner

Cisco ASA 8.4 additional natting and routing in IPsec tunnel

Hi everyone,

I need some help regarding the creation od IPsec tunnel between two Cisco ASA sites (ASA 8.4)

I created the IPsec tunnel and it is working correctly from LAN 58 to LAN 54 and vice versa:

ASA58# show nat
Manual NAT Policies (Section 1)
1 (inside) to (outside) source static OBJ-MainSite OBJ-MainSite   destination static OBJ-RemoteSite OBJ-RemoteSite no-proxy-arp route-lookup
    translate_hits = 5, untranslate_hits = 0

Auto NAT Policies (Section 2)
1 (inside) to (outside) source dynamic INSIDE-NET interface
    translate_hits = 2, untranslate_hits = 0

But additionaly I need to create one more thing:

Lets say that host 192.168.50.10 from LAN 58 (attachment picture) is trying to get outside, is there any possibility that when it gets outside or through some other tunnel that is also part of the network (not shown in the attachment picture) that it is presented as a host from the LAN 54 (172.16.50.10 in this case).

What kind of natting or routing would need to be done to accomplish this, or is ti possible anyway ??

Thanks alot.

 

Everyone's tags (1)