Cisco Firepower firewalls 4100 : need to set up as FTD

[Loc Nguyen]

I have a firewall 4100 . I need to set them up as FTD to work with my FMC

I set up it up as below, but I can ssh but can not https to it. Do you know why?

If you have a good link for setting up this firewall to FTD, pleas share.

Switch Fabric=A

    System Name=mdta-test-fw

    Enforced Strong Password=no

    Supervisor Mgmt IP Address=10.33.192.252

    Supervisor Mgmt IP Netmask=255.255.255.0

    Default Gateway=10.33.192.250

    SSH Mgmt Access Configured=yes

        SSH Mgmt Access IP Address=10.33.192.252

        SSH Mgmt Access IPv4 Netmask=255.255.255.0

    HTTPS Mgmt Access Configured=yes

        HTTPS Mgmt Access IP Address=10.33.192.252

        HTTPS Mgmt Access IPv4 Netmask=255.255.255.0

Thanks

[Rob Ingram]

@Loc Nguyen 

The FTD 4100 has FXOS that runs on the chassis and FTD that runs on top. Configure FXOS mgmt information first, refer to this guide for more information.

https://finkotek.com/cisco-4100-firepower-threat-defense-part-1-fxos/

[Loc Nguyen]

Thank Rob, let me try