I have a small problem with my VPN configuration on two Cisco 2811s. We just got rid of an expensive point to point private WAN link between our two company sites in favor of a site to site VPN. We also provide remote access VPN into the main office with static routes to allow access to hosts on the branch office network as well. When I added the site to site VPN to the configuration, the only thing that "broke" was the ability for remote access VPN clients to connect to hosts in the branch office. Any thoughts on how to get this going? I wondered if it might have to do with something like the "same-security-traffic" intra-interface command that you use on the ASA for a config like this? "debug ip packet <ACL>" with the ACL defining the address pool for remote access clients only sees traffic when I directly access the router from a remote access client.
HIDoes anyone know if there is an easier way than the belowQ. I check connection events for IOC's when requested and sometimes i have to check many url's which i am presently doing one url at a time and is very time consuming, is there a way to check mult...
Cisco Identity Services Engine (ISE) gives you intelligent Integrated protection through intent-based policy and compliance solution. ISE supports external MDM vendor integration to help the customers to look for compliance of a dev...
This video provides the steps to configure the Cisco Threat Response (CTR) and ESA Integration.
This is live on the portal:https://video.cisco.com/video/6159336218001
And on YouTube:https://www.youtube.com/watch?v=UCKIdx5rdFg
I need to migrate from C170 to C190 and have already match to the same Firmware Version. I have a question. Is there any method that can export and import the configuration file instead of form cluster ?