Hello,
I'm trying to setup an IPsec VPN on a 2811 ISR. I obtained and installed a securityk9 eval license from Cisco. However, the "show crypto isakmp" and "crypto isakmp" commands are still not available. -- I have tried doing "reload".
Thanks.
Here's my details:
Cisco IOS Software, 2800 Software (C2800NM-IPBASEK9-M), Version 12.4(24)T3, RELEASE SOFTWARE (fc2)
Cisco 2811 (revision 53.50) with 251904K/10240K bytes of memory.
Processor board ID FTX1201A07L
2 FastEthernet interfaces
1 Serial interface
1 ISDN Basic Rate interface
ga2800#show lic all
License Store: Primary License Storage
StoreIndex: 0 Feature: securityk9 Version: 1.0
License Type: Evaluation
License State: Active, Not in Use, EULA accepted
Evaluation total period: 8 weeks 4 days
Evaluation period left: 8 weeks 4 days
License Priority: Low
ga2800#show crypto ?
eli Encryption Layer Interface
key Show long term public keys
pki Show PKI
ga2800#config t
Enter configuration commands, one per line. End with CNTL/Z.
ga2800(config)#crypto ?
ca Certification authority
engine Enter a crypto engine configurable menu
key Long term key operations
pki Public Key components
ga2800(config)#license ?
agent Configure LIC_AGENT
call-home license call-home config commands
Notice how there is no "isakmp" command.
Also, note how there is no "license boot" command either.
