01-11-2002 08:22 PM - edited 02-21-2020 11:33 AM
We're experimenting to configure a a PIX from outside using CSPM 3.0. Without NAT (Address hiding), we can successfully communicate and deploy config from CSPM 3.0 to PIX. But when we try to add NAT (Address Hiding), we found that the CSPM failed to generate correct NAT (Address Hiding) configuration.
If we move the CSPM 3.0 to PIX inside, everything works fine.... We're using PIX 5.1
Rico
01-18-2002 07:04 AM
Youll need to be inside to deploy the config. You might check with Cisco to see if they have some suggestions for you.
01-22-2002 05:43 PM
Hi there..
I have the same problem with you.....until now there is no solution...plz let me know..if you are succesful configuring IPSEC+NAT with CSPM....
regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide