05-18-2011 02:08 PM - edited 02-21-2020 05:21 PM
Hi all,
Is this how DMVPN is supposed to work?
I have a 3 router lab configured with 2 spokes and a hub and DMVPN is up and working fine except that when I ping from one spoke to another spoke's tunnel address it goes across the dynamic tunnel but when I go from spoke to remote spoke's inside LAN address (which is advertised via EIGRP) it fails.
The hub sees routes for inside addresses from both spokes and the spokes see the inside address for the hub and those respective pings suceed.
Any ideas what I may be leaving out?
I can provide configs and show/debug output if it would help.
Thanks!
Cheers
Xavier
05-18-2011 02:55 PM
Hi Xaver,
Can you post the output of the following from both of the spokes and the hub:
show run int tun n
sh run | sec router
sh run int for the inside interfaces.
Thanks,
Loren
05-18-2011 02:59 PM
Hi Loren
I figured it out after a quick search on Google. Split horizon was my problem. I just used these two commands
no ip split-horizon eigrp 1
no ip next-hop-self eigrp 1
And everything sorted out itself =]
Thanks though
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: