09-26-2011 07:24 AM - edited 02-21-2020 05:37 PM
Hi,
I currently have a Cisco 5520 ASA which is up and running and the users are able to connect to Anyconnect to VPN into the network.
However, users plugged into the internal network inside the ASA are unable to connect to the vpn address and download the Anyconnect Client. I think this may be to do with reverse NAT missing?
I would appreciate any help.
Thanks in advance.
Nisha
09-26-2011 08:23 PM
Could be that it's not enabled on the inside interface.
09-27-2011 12:57 AM
Hi Lee,
If I enable Anyconnect on the inside interface, this will not effect the outside interface will it? Apologies, I'm new to configuring ASAs.
Thanks in advance.
Nisha
09-27-2011 08:07 AM
You can have it enabled on multiple interfaces. Will not interfere with the outside interface
webvpn
enable inside
enable outside
09-28-2011 01:33 AM
Hi Lee,
I enabled the Anyconnect Client on the inside interface but have had no luck.
The users are trying to browse to a vpn address from which they are prompted to install the Anyconnect software. This comes under Network (Client) Access right?
Thanks in advance.
Nisha
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: