FPR1010 AnyConnect Connects but no remote LAN access

[Moamen Elsayed]

Hello,

I have Cisco FPR 1010 and am using AnyConnect V.4,  when i connect from outside the Tunnel is up but i can not access Remote Subnet (Network Behind Inside Interface), I have VPN Pool 10.10.10.0/24 and the Remote Inside Subnet is 192.168.1.0/24,

How can i get Access to That Remote Network after connecting with CiscoAnyConnect

Note: I have Default NAT Rules on all Bridged Interfaces

[Muhammad Awais Khan]

Hi,

What is your Split tunnel policy configured ? Did you allow all traffic through VPN or Split tunnel list defined ?

Further, did you enable "Bypass Access Control policy for decrypted traffic" when configuring VPN Profile ?

Also, make yes to NAT exempt if not done yet.