05-24-2015 05:01 AM
Hi,
as per the attached diagram i need to configure the gre tunnelling but we are using the dynamic nat pool. So how can i configure this i mean what will be the tunnel source and tunnel destination addresses.
05-24-2015 08:21 AM
U want GRE between pc or the routers ??
If router then u can use WAN ips as source and destination, provided ur 3G router support GRE.
05-24-2015 08:45 AM
05-24-2015 08:46 AM
HI VIVEK,
can u tell me the above configuration is correct or not ?
05-24-2015 11:08 AM
Use public ips of both ends as source and destinations.
If you are able to ping tunnel destination from tunnel source, then only GRE tunnel will come UP
07-01-2015 11:18 AM
Posts in this discussion have been modified due to possible misconduct. Please refer to the CSC terms of use for more details.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
hi vivek,
please check the updated diagram there is change in the router wan ip address.
Router configuration
int tunnel 0
ip add 10.10.10.1 255.255.255.0
tunnel source 172.20.31.6
tunnel destination 109.83.208.52 (ip add of 3g router)
3G router configuration
GRE REMOTE ADDRESS- 172.20.31.6
LOCAL TUNNEL ADDRESS-10.10.10.2
REMOTE TUNNEL ADDRESS-10.10.10.1