01-24-2013 07:59 AM
Hi Everyone,
We have two sites and both have Remote access VPN configured.
IF one site VPN fails users automatically switch to other site.
Need to know what commands i can run on ASA to check if Remote VPN failover is there?
Also what lines in running config shhould i look for?
Thanks
Mahesh
Solved! Go to Solution.
01-25-2013 12:58 AM
Depends on your setup, it can vary, below link has someVPN failover setups, you can find some commands to verify the redundancy on your network:
http://www.cisco.com/en/US/docs/ios/12_2/12_2y/12_2yx11/feature/guide/ft_vpnha.html#wp1093554
What you should look at your running config is also depends on your setup, it should be something like: primary, standby or backup.
HTH
01-25-2013 12:58 AM
Depends on your setup, it can vary, below link has someVPN failover setups, you can find some commands to verify the redundancy on your network:
http://www.cisco.com/en/US/docs/ios/12_2/12_2y/12_2yx11/feature/guide/ft_vpnha.html#wp1093554
What you should look at your running config is also depends on your setup, it should be something like: primary, standby or backup.
HTH
01-25-2013 09:17 PM
Hi Rudy,
Thanks for answering the post.
Regards
MAhesh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide