10-26-2011 07:38 PM - edited 02-21-2020 05:40 PM
ASA 5505 8.2.1
ASA 5520 8.4
We currently have a tunnel configured between 2 ASAs
1- Is it possible to assign 1.5 Mbits of Bandwidth(BW) to this tunnel?. Then if Tunnel number 2 is configured I could assign 2 Mbits to that one for example?
I am not referring to prioritizing certain type of traffic over the IPsec tunnel, I am referring to Tunnel 1 has 1.5 Mbits of BW guaranteed for all traffic that goes thru it. Same for tunnel 2
Then
2- How to monitor the amount of BW in an IPsec tunnel?
PLease provide documentation of this is possible
Thanks
Johnny
Solved! Go to Solution.
10-26-2011 11:52 PM
Hi! Please look at this document:
https://supportforums.cisco.com/docs/DOC-1230
___
HTH. Please rate this post if it was helpful. If this solves your problem, please mark this post as "Correct Answer"
10-26-2011 11:52 PM
Hi! Please look at this document:
https://supportforums.cisco.com/docs/DOC-1230
___
HTH. Please rate this post if it was helpful. If this solves your problem, please mark this post as "Correct Answer"
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide