cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7122
Views
30
Helpful
13
Replies

How to Install FL-4330-HSEC-K9 and FL-4330-BOOST-K9

katheer4u
Level 1
Level 1

hi

 

i was try to install boost licence its not installed successfully. and i believe  its will support up to 2Gbif any one know plz advise me thanks 

 

Router #license install bootflash:FDO20432DC6_20200324080332.lic
Installing licenses from "bootflash:FDO20432DC6_20200324080332.lic"
Installing...Feature:hseck9...Successful:Supported
Installing...Feature:booster_performance...Successful:Not Supported
2/2 licenses were successfully installed 
0/2 licenses were existing licenses
0/2 licenses were failed to install
 +++++++++++++++++++++++++++++++++

Router#show license
Index 1 Feature: appxk9
Period left: Life time
License Type: RightToUse
License State: Active, Not in Use, EULA accepted
License Count: Non-Counted
License Priority: Low
Index 2 Feature: uck9
Period left: Life time
License Type: RightToUse
License State: Active, Not in Use, EULA accepted
License Count: Non-Counted
License Priority: Low
Index 3 Feature: securityk9
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
Index 4 Feature: ipbasek9
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
Index 5 Feature: cme-srst
Period left: Life time
License Type: RightToUse
License State: Active, Not in Use, EULA accepted
License Count: 0/0 (In-use/Violation)
License Priority: Low
Index 6 Feature: hseck9
Period left: Life time
License Type: Permanent
License State: Active, In Use
License Count: Non-Counted
License Priority: Medium
Index 7 Feature: throughput
Period left: 3 weeks 3 days
Period Used: 5 weeks 0 day
License Type: EvalRightToUse
License State: Active, In Use
License Count: Non-Counted
License Priority: Low
Index 8 Feature: internal_service

+++++++++++++++++++++++++++++++++++

Router(config)#platform hardware throughput level ?
100000 throughput in kbps
300000 throughput in kbps

+++++++++++++++++++++++++++

Router#show platform hardware throughput level
The current throughput level is 300000 kb/s

 

 

 

 

13 Replies 13

Leo Laohoo
Hall of Fame
Hall of Fame

What firmware is the router running on?

Post the complete output to the command "sh inventory".

Good day

 

Please see the below requested 

 

Router#sh inventory
NAME: "Chassis", DESCR: "Cisco ISR4331 Chassis"
PID: ISR4331/K9 , VID: V05, SN: FDO2218A1LT

NAME: "Power Supply Module 0", DESCR: "250W AC Power Supply for Cisco ISR 4330"
PID: PWR-4330-AC , VID: V01, SN: PST2037N21Q

NAME: "Fan Tray", DESCR: "Cisco ISR4330 Fan Assembly"
PID: ACS-4330-FANASSY , VID: , SN:

NAME: "module 0", DESCR: "Cisco ISR4331 Built-In NIM controller"
PID: ISR4331/K9 , VID: , SN:

NAME: "NIM subslot 0/1", DESCR: "NIM-ES2-4"
PID: NIM-ES2-4 , VID: V01, SN: FOC2312888M

NAME: "NIM subslot 0/0", DESCR: "Front Panel 3 ports Gigabitethernet Module"
PID: ISR4331-3x1GE , VID: V01, SN: JAB092709EL

NAME: "module 1", DESCR: "Cisco ISR4331 Built-In SM controller"
PID: ISR4331/K9 , VID: , SN:

NAME: "module R0", DESCR: "Cisco ISR4331 Route Processor"
PID: ISR4331/K9 , VID: V05, SN: FDO20432DC6

NAME: "module F0", DESCR: "Cisco ISR4331 Forwarding Processor"
PID: ISR4331/K9 , VID: , SN:

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

#show version
Cisco IOS XE Software, Version 03.15.03.S - Standard Support Release
Cisco IOS Software, ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.5(2)S3, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2016 by Cisco Systems, Inc.
Compiled Fri 25-Mar-16 16:59 by mcpre


Cisco IOS-XE software, Copyright (c) 2005-2016 by cisco Systems, Inc.
All rights reserved. Certain components of Cisco IOS-XE software are
licensed under the GNU General Public License ("GPL") Version 2.0. The
software code licensed under GPL Version 2.0 is free software that comes
with ABSOLUTELY NO WARRANTY. You can redistribute and/or modify such
GPL code under the terms of GPL Version 2.0. For more details, see the
documentation or "License Notice" file accompanying the IOS-XE software,
or the applicable URL provided on the flyer accompanying the IOS-XE
software.


ROM: IOS-XE ROMMON

HO-FLXVPN uptime is 2 weeks, 1 day, 12 hours, 39 minutes
Uptime for this control processor is 2 weeks, 1 day, 12 hours, 40 minutes
System returned to ROM by reload
System image file is "bootflash:isr4300-universalk9.03.15.03.S.155-2.S3-std.SPA.bin"
Last reload reason: Reload Command

 

This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.

A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html

If you require further assistance please contact us by sending email to
export@cisco.com.


Technology Package License Information:

-----------------------------------------------------------------
Technology Technology-package Technology-package
Current Type Next reboot
------------------------------------------------------------------
appx None None None
uc None None None
security securityk9 Permanent securityk9
ipbase ipbasek9 Permanent ipbasek9

cisco ISR4331/K9 (1RU) processor with 1665730K/6147K bytes of memory.
Processor board ID FDO2218A1LT
7 Gigabit Ethernet interfaces
32768K bytes of non-volatile configuration memory.
4194304K bytes of physical memory.
3207167K bytes of flash memory at bootflash:.

Configuration register is 0x2102

Router #license install bootflash:FDO20432DC6_20200324080332.lic

The above item in RED is the serial number the license is "attached" to. 

PID: ISR4331/K9 , VID: V05, SN: FDO2218A1LT

The above item in RED is the serial number of the chassis.  The serial number of the chassis and the serial number of the license DO NOT MATCH.  This is why the license file will not load. 

Good Day

 

even i changed the file name but its given error again but Cisco asked me below requested 

Router#show license udi    

SlotID   PID                          SN                          UDI

--------------------------------------------------------------------------------

* ISR4331/K9            FDO20432DC6     ISR4331/K9:FDO20432DC6

 

+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

Router#license install bootflash:FDO2218A1LT_20200324080332.lic
Installing licenses from "bootflash:FDO2218A1LT_20200324080332.lic"
Installing...Feature:hseck9...Failed:
% Error: Duplicate license
Installing...Feature:booster_performance...Failed:
% Error: Duplicate license
0/2 licenses were successfully installed
2/2 licenses were existing licenses
0/2 licenses were failed to install 

 

Change the filename? Why bother?
The license key inside the file is computed against the serial number of the chassis. This is to prevent any "genius" from re-using one license key and installing it into different chassis without paying for it.
One license for one chassis.
For another chassis, contact the License team and they will generate a new one.

Good day

 

Please see the attached error file 

we have contacted with  cisco and there send an new file its also given error message 

i have send them already show inventory file 

Read THIS.

good day

 

i have upgraded IOS then after old licence are gone ?

 

 

Starting from 16.9.X, everything uses Cisco Smart Licensing (CSL).

hi can you please the attached file and advise me the license registered successfully or not

Registration:
  Status: REGISTERED
  Smart Account: Claudion

That is all I cared about.

License Usage:
  License                 Entitlement tag               Count Status
  -----------------------------------------------------------------------------
  ISR_4331_AdvancedUCS... (ISR_4331_AdvancedUCSuite)        1 OUT OF COMPLIANCE
  ISR_4331_Application    (ISR_4331_Application)            1 OUT OF COMPLIANCE
  ISR_4331_Security       (ISR_4331_Security)               1 AUTHORIZED
  Boost Performance fo... (ISR_4331_BOOST)                  1 OUT OF COMPLIANCE
  ISR_4331_Hsec           (ISR_4331_Hsec)                   1 OUT OF COMPLIANCE

Other than Security, which feature are intending to use?

we have purchase 3 routers 4331 license Cisco booster and hsec but its registered successfully .still showing under compliance  other router also showing all are out of complaisance

 

show license summary (here its showing OUT OF COMPLIANCE)

  Boost Performance fo... (ISR_4331_BOOST)                  1 OUT OF COMPLIANCE
  ISR_4331_Hsec           (ISR_4331_Hsec)                   1 OUT OF COMPLIANCE

# #show platform software license dlc  ( here its showing Permanent License)

Index 4  Feature:           hseck9
	Permanent License:  1
	EVAL RTU License:   0
	RTU License:        0
	Paper License:      0
Index 5  Feature:           throughput
	Permanent License:  0
	EVAL RTU License:   1
	RTU License:        0
	Paper License:      0
Index 6  Feature:           booster_performance
	Permanent License:  1
	EVAL RTU License:   0
	RTU License:        0
	Paper License:      0

 

Send an email to the License Team.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: