Hello.
I can't configure remote access to 3745 over ISDN-modem with autentication on RADIUS.
Remote access over analog-modem work fine.
When I try connect over ISDN-modem on "interface BRI2/0", after autetication, ISDN-modem dissconnected.
This is show ver:
---------------
Cisco IOS Software, 3700 Software (C3745-IPVOICE-M), Version 12.3(11)T2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2004 by Cisco Systems, Inc.
Compiled Fri 29-Oct-04 06:38 by cmong
ROM: System Bootstrap, Version 12.2(8r)T2, RELEASE SOFTWARE (fc1)
Router uptime is 1 week, 21 hours, 5 minutes
System returned to ROM by power-on
System restarted at 13:45:37 PRM Tue Apr 5 2005
System image file is "flash:c3745-ipvoice-mz.123-11.T2.bin"
Cisco 3745 (R7000) processor (revision 2.0) with 118784K/12288K bytes of memory.
Processor board ID JHY0807K0QR
R7000 CPU at 350MHz, Implementation 39, Rev 3.3, 256KB L2, 2048KB L3 Cache
2 FastEthernet interfaces
16 ISDN Basic Rate interfaces
24 terminal lines
2 Voice FXS interfaces
DRAM configuration is 64 bits wide with parity disabled.
151K bytes of NVRAM.
31744K bytes of ATA System CompactFlash (Read/Write)
Configuration register is 0x2102
---------------
In attach:
config - current configuration 3745
dabug_radius - debug AAA Authentication
Anybody can help me?
